REF EXTBN_6ME29873452

Everbuild External Frame Sealant Brown C3 Size Cartridge Pack of 6

Product out of stock
Product out of stock
Product details
  • Color
  • Type of product

EVERBUILD EXTERNAL FRAME SEALANT is an acrylic sealant, suitable for internal and external use around window and door frames. The product provides a permanently flexible long lasting seal that adheres to virtually all materials. It contains a powerful anti-fungicide to prevent mould growth, and can be overpainted.

Permanently flexible
Adheres to most surfaces.
Mould resistant.
Easy clean up
Certified under the harmonized European standard EN15651 for fa ade interior and exterior applications in compliance with the Construction Product Regulation.

Areas For Use
Internal and external sealing around timber and metal window and door frames,
Internal sealing around Pvcu window and door frames.
Sealing cracks and gaps in brickwork, stone and concrete.

Not for use in conjunction with bitumen or asphalt.
Not for use externally when rain is imminent (within 6 hours at 20 C, 24 hrs at 10 C.) Note that damp or humid conditions may significantly extend the cure.
Do not attempt to abrade when cured.
Do not overpaint until a surface skin has formed (allow 24 hours). Overpainting is recommended externally to prologue the working life of the product especially in areas prone to high/low temperature variations.
Note: this product is a flexible. Certain poor quality paints (especially certain vinyl matts) have very little movement in the dry film. It is possible for the dry paint film to crack if movement is excessive.
Do not use externally around Pvcu Use Silicone 450.

Surface Preparation
All surfaces must be clean and dust free. All loose or flaking surface coatings, and old sealant and mastic joints, should be removed before application. Highly porous substrates such as new plaster should first be primed with Everbuild PVA bond diluted 1:4 with water. This product can be applied to slightly damp, but not wet surfaces.

Cut the tip of the cartridge taking care not to damage the thread. Apply nozzle and cut cleanly at an angle of 45 with an opening slightly larger than the gap to be sealed. Apply using a standard sealant gun. Best results will be obtained by keeping an even pressure on the gun trigger and keeping the gun at a constant angle to the surface being sealed. Smooth down within 20 minutes of application using a wetted spatula, piece of wood or wetted finger. Care should be taken at this point not to saturate the surface as this will delay drying. Any excess sealant etc. can be removed using a sponge and warm water.

Do you need more information?

We're here to help!
You are here:

The biggest marketplace in Europe for DIY, Home & Garden

  • Millions of products

    Loads more than in a shop, and without needing to navigate all the aisles

  • Delivery to your home or click & collect

    Whichever suits you best

  • Hundreds of dedicated experts online

    Like Macgyver but online