0-10V PWM Analog-to-Digital Board, Signal-to-Voltage Converter, Durable for Interface Switching, 1 Piece

Features: 1. PWM converts digital signals to an analog signal (0 to 10V). 2. The input digital signal can be a 0-100% level PWM signal at 5V or 24V. 3. The output analog signal can be a voltage of 0 to 10V. 4. Can be used for industrial PLC control panels or other signal interface switching. 5. This module is easy to wire and convenient to use. Specifications: Features: PWM converts digital signals to an analog signal (0 to 10V). The input digital signal can be a 5V or 24V level PWM signal at 0-100%. The output analog signal can be a voltage of 0 to 10V. Can be used for industrial PLC control panels or other signal interface switching. This module is easy to wire and convenient to use. Specifications: Condition: 100% brand new and high quality Current: Max. 12 mA Power input voltage: 12-30 V Size: Approx. 5 x 4.5 cm / 1.97 x 1.77 inches Weight: 20 g Quantity: 1 pc Usage method: PWM signal input frequency range: 1 kHz - 3 kHz PWM signal input level range: 4.5 V to 10 V peak-to-peak, jumper inserted at 5 V. This type of signal is mainly intended for conventional industrial control boards (such as MACH3 boards), for 5 V for the CPU interface. 12 to 24 V peak-to-peak, jumper inserted at 24 V. This type of signal is mainly intended for the conventional PLC interface. Explanation of the 0-10V analog voltage output: When the signal input port is not connected, the output port provides 0V. The first time we turn on this module, it is best to calibrate it: find a signal with a 50% duty cycle, connect it to DIN-, DIN+, and the amplitude corresponds to the corresponding jumper. When the frequency is between 1 kHz and 3 kHz, use a multimeter to test AO, GND. The meter should display approximately 5.4V. We adjust the potentiometer on the converter module so that the multimeter reads approximately 5.4V. Once this is done, we have calibrated and matched the pulse signal with this converter module. The module has a resolution of 0.1V. Output current: 10mA. If the duty cycle is opposite to the voltage, we can select the PWM STEP LOW/ACTIVE output pin for the MACH3 software. Package includes: 1 x PWM signal-to-voltage converter. Note: After power-up, when there is no input signal, the output is 0V. There is an output only when there is an input.