1 x Glow in the Dark Anti-Slip Strip, Suitable for Indoor and Outdoor Use, 10m x 5cm

LIGHT-UP REMINDER: The green fluorescent film strip glows in the dark, marking the stairs and preventing you from tripping on the last step at night. MORE RELIABLE NON-SLIP: Made with 80-grit aluminum oxide, the tape offers excellent and long-lasting slip resistance. This eliminates the worry of slipping and makes you feel more confident when using the stairs. DURABLE AND RELIABLE ADHESIVE: The high-quality adhesive is resistant to tearing and abrasion. It leaves no residue when replaced or repositioned and will not damage the floor. DOOR-FRIENDLY: Ideal for marking stair edges and dangerous steps, such as on loading docks, basement stairs, movie theater stairs, bunk beds, garages and any other potentially dangerous areas. EASY APPLICATION: Easy to apply and use: peel off the protective film and unroll any bubbles. Dimensions: 50 mm wide x 10 m long, luminous. Specifications: Main material: Gravel, paper, strong adhesive, fluorescent. Application temperature: 14–140°C / -10–60°C. Suitable for: Flat, clean, smooth, hard floors or surfaces (e.g., floors, stairs, steps, corridors, ramps, vehicle steps, emergency exits, scaffolding, cinema aisles, etc.). Not suitable for: Rough, soft, moist, dusty, or porous surfaces. Application: 1. Ensure contact surfaces are flat, clean, and dry before application. 2. Cut the tape to the desired length and round the corners with a utility knife. 3. Peel off the backing paper and position the tape in the desired location. (In cold temperatures, you can gently heat the tape with a hair dryer and smooth it out for best results.) 4. Press the tape evenly from the center to both ends. (The applied strip was left to dry for 24 hours.) 5. Place the strip under a light source for a short time so that it glows in the dark. Tips: The strip will absorb light for 15-20 minutes. The light source can remain on for a while longer. (The more light it absorbs, the brighter and longer the strip will glow. After that, the brightness will gradually decrease.) If the light strip is initially dim, that's fine. It will become significantly brighter soon after absorbing light.