10 pairs of 3-section extendable drawer runners, large load-bearing rails for home office, 18 inches

• 1. High load capacity, its maximum load capacity is 100 pounds and it can support heavy drawers.
• 2. With a width of 45 mm, it can fit the same type of drawers and support a reasonable load.
• 3. Full extension 3x ball bearing, it can extend further when the drawer is pulled out.
• 4. The set includes 10 pairs of sliding rails, which can accommodate 10 drawers.
• 5. Cold-rolled steel material, it can ensure that the drawer can be opened smoothly without excessive resistance.

French: Item Type: Drawer Slide

Width: Approx. 45 mm/1.8 in

Maximum Load: 100 lbs

Material: Rolled Steel Cold-rolled, double-row solid steel balls

Surface treatment: black electrophoretic

Material thickness: approximately 1.2 mm/0.05 in

How to use:

1. Open the package.

2. When installing the drawer slide, the inner rail must be removed from the main body of the drawer slide. The disassembly method is also very simple. There will be a spring-loaded loop on the back of the drawer slide. Remove the rail.

3. First, install the outer rail and the middle section of the split slide on both sides of the drawer housing, then install the inner rail on the side panel of the drawer. If it is a finished piece of furniture, the drawer body and the drawer side panels will be pre-drilled with holes for easy installation, and you will need to drill the holes yourself.

4. When installing the drawer slides, it is recommended to assemble the drawer as a whole. There are two holes on the slide to adjust the vertical and front distance of the drawer. At the same time, it is necessary to ensure that the left and right slides are in the same horizontal position; they cannot be too different.

5. Next, install the inner and outer slides. Secure the inner slide to the length of the drawer unit with screws in the measured position (note that the inner slide, the center slide, and the outer slide, once installed and secured, must be kept in the same position).

6. Tighten the corresponding holes of the two screws.

7. Follow the same method on the other side, but be sure to keep the inner rails on both sides horizontal and parallel.

8. Note that if the left and right sides of the center and outer rails are not level in the previous step, and the tamping cannot be pushed forward, you must check the position of the outer rail or adjust the position of the inner rail to match the outer rail.

9. After installation, pull the drawer out for testing. If there is a problem, it must be readjusted. If the push-pull action is smooth, the installation can be completed.