100cm Transparent Anti-Overflow Shower Barrier for Walk-in Showers, Self-Adhesive Silicone Threshold Barrier and Retention System for Bathroom Floor

Product never used, packaging damaged during transport. Unopened, repackaged in our warehouses, in perfect working order, warranty available. Good quality and easy to clean: The overflow threshold is made of food-grade organic silica gel, which is highly effective at blocking water, separating wet and dry areas, corrosion-resistant, high-temperature resistant, wear-resistant, and odorless. The material is flexible and can be cut to size. The flood barrier surface is smooth and easy to clean; simply wipe it with a damp cloth. Practical design: The bottom edge of the shower seal has a 90° right angle, suitable for corner installation; the shower floor edge has a gentle slope and rounded curve, providing good water retention, a low profile, making it difficult to bump into, and ensuring stability and safety; built-in self-adhesive backing for easy installation. Installation Steps: Clean and Measure. Clean the surface to ensure it is free of dust and dirt. Measure the desired length and make a mark. Peel and Stick. Cut the strip to your desired length, then peel off the backing and press it onto the surface. Seal. Caulk. Seal the edges with silicone to create a tight seal and make it more secure, especially if installing on cement tiles. Let Dry. Allow the strip to dry completely and avoid water for 24 hours. Note to Buyers: 1. The adhesive on the underside of the water barrier may not have fully melted due to weather conditions. Heat the underside of the shower barrier with a hairdryer before use to ensure the adhesive melts completely and bonds better. 2. Seal the edges with silicone after installation to prevent it from coming loose later and to ensure a longer lifespan (sealable not included). 3. The shower enclosure seal height is only 12 mm; it cannot block the water flow with a height greater than 12 mm.