100cm Transparent Shower Barrier - Anti-Overflow for Walk-in Showers - Self-Adhesive Silicone Shower Threshold Barrier and Retention System for Bathroom Floor

Good quality and easy to clean: The overflow threshold is made of food-grade organic silica gel, which is highly effective at blocking water, separating wet and dry areas, and is corrosion-resistant, high-temperature resistant, wear-resistant, and odorless. The material is flexible and can be cut to size. The flood barrier surface is smooth and easy to clean; simply wipe it with a damp towel. Practical design: The bottom edge of the shower seal has a 90° right-angle design, suitable for corner installation; the shower floor edge has a gentle slope and rounded curve, providing good water retention, a low height, and is not easy to bump into, ensuring stability and safety. Integrated self-adhesive backing, easy to install.

Installation Steps

Clean and Measure: Clean the surface to ensure it is free of dust and dirt. Measure the length you wish to stick and make a mark. Peel and Stick: Cut the strip to your desired length, then peel off the backing and press it onto the surface. Seal: Seal the edges with silicone to make it stronger, especially if installing on cement tiles. Let Dry: Allow the strip to dry completely and avoid water for 24 hours.

Note to Buyers

1. The adhesive on the underside of the water barrier may not have fully melted due to weather conditions.

Heat the underside of the shower gate with a hairdryer before use so the adhesive melts completely and bonds better.

2. Seal the edges with silicone after installation to prevent it from coming loose later and to make it last longer (Sealant is not included in the package)

3. The shower enclosure seal is only 12 mm high; it cannot block the water flow with a height greater than 12 mm.