100 x Tile Leveling System Floor Kit
1. Wear-resistant, recyclable, reusable.
2. Easy to use in DIY operation.
3. Balance tiles in the same horizontal position.
4. Improve tile installation speed.
5. Reduce installer fatigue / pressure.
6. There is virtually no crackless, flat surface.
7. This reduces the need for sharpening and polishing.
8. Avoid shingles from movement during solidification.
1. Name: Tile Leveling System Floor Kit
2. Model: D91955
3. Material: High Quality PP + Stainless Steel
4. Color: Black+Orange
5. Applicable Brick Difference: 2-6mm / 0.08-0.24 "
6. Applicable Tile Thickness: 3-16mm / 0.12-0.63 "
Lay the first tile, leaving more than 2mm (with cross joints). Close to tile.
Insert T-pins next to the gap between the tiles.
Then rotate 180 degrees and the T-needle is attached to the bottom of the two tiles.
Adjust the cover by hand / special wrench until the two tiles are on the same level.
After leveling for about 5-6 hours, before the cement / adhesive is completely dry, rotate the lid in reverse and take off the 180 degree T needle until the floor is removed.
Avoid not removing the T-leveling tile system
1. Ceramic tile joints are 2mm or more (cross joints are recommended)
2. When leveling, adhesive cement or tile cement around T-type leveler should be cleaned.
3. Remove the T-type straightener about 5-6 hours after leveling before the tile or cement binder is completely dried.
1. Due to the different of the monitor and the light effect, the actual color of the item may be slightly different from the color shown in the pictures. Thank you!
2. Please allow slight measurement deviation due to manual measurement.