0-10V 8 Direction Environmental Signal Output Polycarbonate Wind Speed ​​Sensor Anemometer (Specification: 8 azimuth connection 0.7 m)

1. The outer casing is made of polycarbonate with high mechanical strength, high hardness, and corrosion resistance. 2. Small size, lightweight, easy to carry and assemble, with 8 direction indicators for ease of use. 3. With a smooth internal bearing system, it ensures accurate data collection and is more convenient to operate. 4. Rust-resistant, anti-exposure, high impact resistance, suitable for long-term use in outdoor environments, and electromagnetic interference-resistant treatment; can be used with four- and three-wire connections. 5. It adopts a high-performance bearing, has low rotational resistance and accurate measurement, and is widely used for wind direction measurement in greenhouses, environmental protection, weather stations, ships, docks, and aquaculture. Specification: Condition: 100% Brand New Item Type: Wind Speed ​​Sensor Material: Polycarbonate. Application: Widely used for wind direction measurement in greenhouses, environmental protection, weather stations, ships, docks, and aquaculture. Power Supply: Wide input voltage range of 10-30VDC. Only a 24V power supply is available for 0-10V output equipment. Parameter: DC Power Supply (default) 10-30V DC. Maximum Power Consumption Output Voltage: 1.2W. Transmitter Circuit Operating Temperature: -20°C to +60°C, 0%RH-80%RH. Measurement Range: 8 directions. Dynamic Response Time: ≤0.5s. Output Signal: 0-10V Voltage Output. Load Capacitance Output Voltage Resistance: ≤250Ω. Calculation Method: Output Comparison Table 0-10V Output Value (V) Corresponding Wind Direction 0 North Wind 1.4286 Northeast Wind 2.8571 East Wind 4.2857 Southeast Wind 5.7143 South Wind 7.1429 Southwest Wind 8.5714 West Wind 10 Northwest Wind Product Size: Approx. 23.5 x 18.5 cm / 9.3 x 7.3 inches Weight: Approx. 317g / 11.2oz Common Problems and Solutions: No Output or Output Error Possible Causes: 1) The error corresponding to the range causes the PLC calculation error. Refer to the range technical specifications. 2) The wiring method is incorrect or the wiring sequence is incorrect. 3) The supply voltage is incorrect (24V supply for the 0-10V type). 4) The distance between the transmitter and the collector is too long, causing signal interference. 5) The PLC's collector port is damaged. 6) Physical damage. Package list: 1 x wind speed sensor, 1 x cable, 1 x screw kit (4 x screws, 4 x nuts). Note: 1. The user should not disassemble the sensor themselves and should not touch the sensor core to avoid damaging the product. 2. Keep the sensor as far away as possible from high-power interference equipment to avoid inaccurate measurements, such as inverters, motors, etc. When installing or removing the transmitter, the power supply must be disconnected first, and water inside the transmitter can cause irreversible damage. 3. Keep away from chemicals, oil, dust, etc. to avoid directly invading the sensor, do not use it for long periods under condensation and in extreme temperature environments, and avoid cold and heat shocks.