12-piece 12V to 24V IP65 waterproof RGB color switch panel, universal, suitable for trucks, boats, off-road vehicles, ATVs, UTVs and SUVs

Features:1. Robust Construction: Made of CNC-machined aluminum, this car control panel is built to last and can withstand shocks and wear.
2. Water and Dust Resistant: With an IP65 rating, this switch panel is fully protected against rain and debris, ensuring reliable operation in any environment.
3. Long Lifespan: The plastic housing is designed with a gap on both sides to help dissipate heat and keep the controller operating efficiently, with a lifespan of up to 30,000 hours.
4. ON/OFF Button: A red button is designed on the left side of the switch panel to turn the system on and off with a single key; handle the unexpected with ease.
5. Each press changes the brightness to a different level.
Long press: to access adjustment mode, choose between momentary and strobe modes.Long press again to exit adjustment mode.
Backlight color adjustment
Short press: cycle through a single color (loops 1 to 8 in order)
1.Red 2.Orange 3.Yellow 4.Green 5.Cyan 6.Blue 7.Purple 8.White
Long press: gradual change, jump, breathing switch (cycles 9-11 in sequence)
9. Gradual change: Red, orange, yellow, green, cyan, blue, violet
10.Jump: Red, orange, yellow, green, cyan, violet
11.Breathing: Red, orange, yellow, green, blue, blue, violet
3 lighting modes
Constant light, instant mode, strobe mode, adjustable at will
Step 1: Press and hold the brightness adjustment button for 1 second.When the red backlight flashes, you are in momentary adjustment mode.
Step 2: Press the button you wish to adjust (instant mode can be selected from 12 buttons), then press the ON/OFF button to confirm. The adjustment is complete..
Step 3: Press the ON/OFF button again to exit setup mode.
Strobe Mode
Step 1: Press and hold the brightness adjustment button for 1 second, and the red backlight will flash (Note: This is the instant setting state; please refer to the specific steps).
Step 2: Then briefly press the brightness adjustment button, and when the blue backlight flashes, you will enter strobe setting mode.
Step 3: Press the desired setting button (the strobe mode can be selected from 12 buttons), then press the ON/OFF button to confirm. The setting is successful at this point.
Step 4: Press the ON/OFF button again to exit setup mode..

Package List:1 x 12-gang switch panel, 1 x circuit breaker, 1 x reset switch, 10 x cable ties, 1 x manual, 5 x cable harnesses, 5 x brackets, 2 x function stickers, 1 x accessory pack (23 pieces), 1 x screwdriver