120W Electric Water Pump, 10L/min, Diaphragm, Self-Priming, for 12V/10A High Pressure Washer

Features:1.The product has stable and reliable performance and a long service life.
2.120W, strong output power, maximum lift of 130m.
3.The product is compact and easy to install.
4.The theoretical flow rate of the pump can reach 10L/min.
5.The product is widely used in: high-pressure cleaners, water spraying, pesticide spraying, garden watering, filling machines, and other equipment.
Specifications:Feature:
The product has stable and reliable performance and a long service life.
The product features overcurrent protection and is safer to use.
120W, high output power, maximum lift height of 130m.
The product is compact and easy to install.
The theoretical flow rate of the pump can reach 10L/min.
The products are widely used in: high pressure washer, water spraying, pesticide spraying, garden watering, filling machines and other equipment.
Specification:
Maximum power: 120W
Maximum pressure: 13KG
Working pressure: 8G
Opening flow: 10L/m
Vertical suction: 1.5m
Lift: 130m
Package list:
1 * Pump
1 * Filter net
1 * Pump handle
3 * Installation screws
1 * Spare fuses
Note:
1. The actual color of the product may vary from the photo due to light.
2. There may be slight deviation in product measurement.3. Please note that this product does not have any function to control the faucet.
4.If the product is connected to a faucet, please ensure that the faucet is turned on.If the tap is not opened, the pump will run dry and will burn out.
Operating Instructions:
1.Connect the pump to the inlet and outlet hoses.Ensure that the connection between the inlet and outlet hoses and the pump is airtight; otherwise, it will result in low pressure or a water leak.(Tip: There are arrows on the pump cover to indicate the direction of water inlet and outlet. The direction of the arrow is the direction of water outlet.)
2.Install the filter at the inlet end. The filter density should preferably be greater than 80 mesh.(i.e., 80 holes per square centimeter)
3.Connect the microdiaphragm pump to the motor. The electrical parameters of the connected power supply must meet the motor's input requirements.
4.Turn on the power and the motor pump will start operating.
5.The water will be dispensed for 5 to 10 seconds; purge the air from the pump and the pipeline.Once the water flow is stable, temporarily turn off the power and connect the water gun or pump head.