120W electric water pump, 10L/min, self-priming diaphragm pump for 24V/5A pressure washer

Features: 1. The product has stable and reliable performance and a long service life. 2. 120W, strong output power, maximum reach of 130m. 3. The product is compact and easy to install. 4. The theoretical pump flow rate can reach 10L/min. 5. The product is widely used in: high-pressure washers, water spraying, pesticide spraying, garden watering, filling machines, and other equipment. Specifications: Feature: The product has stable and reliable performance and a long service life. The product is equipped with overcurrent protection and is safer to use. 120W, strong output power, maximum reach of 130m. The product is compact and easy to install. The theoretical pump flow rate can reach 10L/min. The product is widely used in: high-pressure washers, water spraying, pesticide spraying, garden watering, filling machines, and other equipment. Specification: Maximum Power: 120W Maximum Pressure: 13KG Working Pressure: 8G Opening Flow Rate: 10L/min Vertical Suction: 1.5m Lift: 130m Package List: 1*Pump 1*Filter Net 1*Pump Handle 3*Installation Screws 1*Spare Fuses Note: 1. The actual color of the product may differ from the picture due to lighting. 2. There may be a slight deviation in the product measurements. 3. Please note that this product does not control the faucet. 4. If the product is connected to a faucet, ensure the faucet is turned on. If the faucet is not turned on, the pump will run dry and may burn out. User Guide: 1. Connect the pump to the inlet and outlet hoses. Ensure the connection between the inlet and outlet pipes and the pump is airtight; otherwise, low pressure or a water leak will occur. (Tip: Arrows on the pump cover indicate the inlet and outlet directions, and the direction of the arrow is the direction of water discharge.) 2. Install the filter at the inlet end. A filter with a mesh size greater than 80 (i.e., 80 holes per square centimeter) is recommended. 3. Connect the microdiaphragm pump to the motor. The power supply must meet the motor's input requirements. 4. Turn on the power, and the pump will start. 5. Allow water to flow for 5 to 10 seconds to purge air from the pump and pipeline. Once the water flow is stable, temporarily turn off the power and connect the water gun or pump head.