12V Battery Cut-Off Switch – Remote Control Switch – 200A for Car and Boat – Easy Installation – DC12V

Application: New high-quality remote battery disconnect switch. This electromagnetic remote battery switch allows you to move the battery tab under the hood to your hand. 12V remote kill switch, operating voltage range 11-15V, suitable for most cars, minivans, agricultural vehicles, etc.

LOW POWER CONSUMPTION: The switch consumes 5W while in standby and approximately 3W when in operation, which is more energy-efficient than a new car. The external antenna makes the signal farther and stronger. Only the battery is turned on/off; it cannot start your engine. The design is disabled by default.

HIGH-QUALITY MATERIAL: The power-off switch is made of ABS, copper, and silver, offering high hardness, shock resistance, durability, and resistance to deformation and breakage. Anti-aging for maximum durability. High-quality products provide you with quality assurance and a longer lifespan.

EASY INSTALLATION: Remote car battery connection system; control your car's power system with the remote control, with a control distance of 48.78m. Easy to install, not easy to fall off; just a few steps to complete the installation. Practical and economical to fully meet your needs.

Easy Installation: Remote car battery connection system, controls your car's power supply with the remote control, control distance of 48.78m. Easy to install, not easy to fall off, just a few steps to complete the installation. Practical and economical to fully meet your needs.

Remote car battery disconnect switch, Auto On Off Kill Switch System, main circuit breaker switch

Installation Method:
1: The red wire is connected to the positive terminal of the battery and the black wire is connected to the negative terminal of the battery. This is the power supply for the switch, and the remote control switch consumes very little energy. 2: The two large terminals of the relay switch constitute the main switch. An incoming line and an outgoing line, in no particular order, act as the on/off switch. 3: During the control of the negative positive start-up, one large terminal is connected to the negative positive of the battery, and one large terminal is connected to the negative positive of the battery (the positive positive is also the same).

Specification:
Item Type: Remote Battery Connection Switch Material: ABS, Copper, Silver Battery Model: CR2016x1 Battery Capacity: 75 mAh Operating Voltage: DC11-15V Rated current: 120 A-200 A Starting current: 200 A-360 A (less than ten seconds) Standby current: 0.005 A Switch Size: Approx. 45x45x45mm/1.77x1.77x1.77in

Package List:
2 remote controls, 1 main power switch, 1 copper terminal, 2 battery clips, 1 copper adapter

Note:
After installation, when the relay switch is activated, battery power consumption will increase. When you leave the car, the main power supply must be switched off with the remote control to avoid power loss due to excessive power consumption and a starting failure.