2 Channel Relay Module with Optocoupler Isolation High and Low Level Trigger(5V)

1、The module adopts high-quality relays with normal interface and maximum load: AC 250V/10A, DC 30V/10A.

2、Using SMT optocoupler isolation, it has strong driving ability and stable performance; trigger current is 5mA.

3、Modules can be triggered by setting high or low levels through wire jumper.

4、Fault-tolerant design, even if the control line is broken, the relay will not move.

5、The interface design is humanized. All interfaces can be directly connected through the terminal, which is very convenient.

Feature:

The module adopts high-quality relays with normal interface and maximum load: AC 250V/10A, DC 30V/10A.

Using SMT optocoupler isolation, it has strong driving ability and stable performance; trigger current is 5mA;

Modules can be triggered by setting high or low levels through wire jumper.

Fault-tolerant design, even if the control line is broken, the relay will not move.

The interface design is humanized. All interfaces can be directly connected through the terminal, which is very convenient.

Equipped with 4 fixed screw holes, easy to install.

Specification:

Working voltage: 5V, 12V, 24V(Optional)

Max load: AC 250V/10A; DC 30V/10A

Channel: 2

Product dimension: 50*41*18.5mm / 2*1.6*0.7in

Power light: Green

Relay light: Red

Board color: Red

Package list:

1 * Relay Module

Note:

Module interface:

1. DC+: Connect the positive pole of the power supply

2. DC-: Connect power supply negative pole

3. IN1:1 signal trigger terminal, can set high or low level control relay suction

4. IN2:2 signal trigger terminal, can set high or low level control relay suction

Relay output:

1. NO1: 1 channel relay usually opens the interface. The relay is suspended before suction and short-connected with COM1 after suction.

2. COM1: 1 channel relay common Interface

3. NC1: 1 channel relay normally closed interface, short connection with COM1 before relay suction, suspension after suction

4. NO2: 2 channel relay often opens interface. The relay is suspended before suction, and is short-connected with COM2 after suction.

5. COM2: 2 channel relay common interface

6. NC2: 2 channel relay normally closed interface, short Connection with COM2 before relay suction, suspension after suction.

High and low level trigger selector:

1. S1 is the trigger selection of high and low level 1 channelrelay.

2. S2 is the trigger selection of high and low level 2 channelrelay.

3.com and low short connection, the corresponding relay is low-level trigger, com and high short connection is high-level trigger.