220V DN10 3/8" Normally Closed Solenoid Valve, Zinc Alloy Electromagnetic Electric Valve for Water, Oil, Air, Gas, Diesel - LIAIKI

【Normally Closed Solenoid Valve】 The solenoid valve is an actuator for industrial process automation control systems. The device can be automatically activated or deactivated upon receiving an electronic control signal to perform on/off control or regulate the flow of fluid in the pipeline. For use with pipelines carrying water, air, oil, and low-viscosity, non-corrosive fluids. 【Installation Method】The direction of water flow is indicated on the valve body. If installed in the opposite direction, the solenoid valve will not function correctly. There are two wires to connect, one to the live wire (phase) and the other to the neutral wire (one wire to phase and the other to neutral, regardless of the direction). (Note: this is a 220-volt system.) The solenoid valve can be used for cold water and hot water up to 80 degrees Celsius. 【Horizontal Installation】This solenoid valve is designed for horizontal indoor installation in a dry environment. If used outdoors, the coil must be well protected from water. Solenoid valves can be widely used in textiles, printing, chemicals, plastics, rubber, pharmaceuticals, food, building materials, machinery, household appliances, surface treatment, etc. 【To Shut Off Water Supply in Case of Flooding】Especially in the event of flooding, a normally closed solenoid valve is necessary because in the event of a power outage or interruption, the solenoid valve closes and isolates the circuit, whereas a normally open solenoid valve requires current to close. 【Water-Type Solenoid Valve】Suitable for use with water or other liquids. It can automatically or remotely control the flow of working fluids, such as water, oil, and other liquids. The valve is sealed with rubber, significantly reducing the need for cleaning the working fluid, and the opening and closing speed and reliability are high. Zinc alloy body + copper coil. Specification: Body Material: Zinc alloy body + copper coil Sealing Material: NBR nitrile rubber Suitable for: Water, gas, oil Control Type: Normally closed (on, off) Thread Diameter: 2W-10 3-point (3/8", DN10) Flow Caliber: 4mm Temperature: -5℃ ~ 80℃ Operating Pressure: 1 MPa Packaging Included: 1 x solenoid valve