220V DN10 3/8" Normally Closed Solenoid Valve Zinc Alloy Solenoid Electric Valve for water oil air gas diesel

【Normally closed solenoid valve】Solenoid valve is an actuator for industrial process automation control systems. The device can be turned on or off automatically after receiving the electronic control signal to perform on/off control or flow regulation of the fluid medium in the pipeline. For use with lines in water, air, oil and low viscosity non-corrosive fluid applications.

【 Installation method】The direction of water flow is marked on the valve body. If installed in reverse, the solenoid valve will not work properly. There are two wires to be connected, one on the phase, the other on the neutral. One wire on the phase the other on the neutral regardless of the direction (be careful, it's 220 volts). The solenoid valve can be used for cold water and hot water up to 80 degrees.

【Horizontal installation】This solenoid valve is designed to be installed horizontally indoors in a dry environment. If used outdoors, the coil part should be well protected from water. Solenoid valves can be widely used in fabrics, printing, chemicals, plastics, rubber, pharmaceuticals, food, building materials, machinery, household appliances, surface treatment, etc.

【To cut off the arrival of water if flooding】Especially for a case of flooding you need a normally closed solenoid valve because in the event of a lack of current or a cut the solenoid valve closes and isolates the circuit with the normally open solenoid valve it takes current to close it.

【Water type solenoid valve】It is suitable for working with water or liquid. It can automatically control or remotely control the continuity of working fluid, such as water, oil and liquids. Since the valve is sealed with rubber, the cleaning of the working fluid is greatly reduced, the opening and closing speed is high, and the reliability is high. Zinc alloy body + copper coil.

Specification:

Body material: Zinc alloy body + copper coil

Sealing material : NBR nitrile rubber

Use liquid: water, gas, oil

Control form: Normally closed (power on, power off)

Thread diameter : 2W-10 3 point (3/8", DN10)

Flow gauge: 4mm

Temperature: -5℃ ~80℃

Use Pressure: 1 (mpa)

Package Included: 1 x Solenoid Valve