230V AC Brass Solenoid Valve G1/2" DN20 Brass Magnetic Solenoid Valve 0-10 bar Water Inlet NC Water Distribution Valves Direct Acting Solenoid Valve for Water/Air

【High Quality】: The solenoid water valve is made of brass with a stainless steel spring sleeve, and the internal components are also stainless steel. The brass solenoid water valve adopts a direct-acting, pressure-free diaphragm structure, which expands its range of applications. The flat diaphragm structure ensures reliable opening and closing, improving the product's lifespan. 【Specifications】: Flow diameter: 16 mm; Input voltage: AC 220 V ± 10%; Power: 15 W; Thread size: G1/2" BSPP (DN15); Pressure: 0-1.0 MPa, Liquid temperature: -5°C to 150°C; Type: Normally closed N/C, water valve; Electrical protection rating: IP 65; Seal material: Viton.
Connection method: Ground is connected to the center pin, the left and right pins are L (+) and N (-) respectively. The assignment is variable. We recommend a cable with a minimum cross-section of 0.5 mm², outer diameter of 7 to 9 mm. Brass solenoid valves must be mounted horizontally and should not be used directly with cable reels. Note that the arrows on the valve housing must be aligned with the direction of liquid flow in the pipeline.
[Function]: Since the magnetic coil requires only a small amount of energy after opening/closing, the remaining energy is released as heat. It It is therefore normal for the solenoid valve to become hot during prolonged operation (up to approximately 80°C). To ensure a long service life, electrically operated brass solenoid valves should not operate for more than 8 hours.
Wide range of applications: Our brass solenoid valve can be widely used in domestic, commercial, and medical applications such as traditional irrigation, plant spraying, and data center cooling. Suitable for non-corrosive water, gas, and oil, such as water, air, natural gas, petroleum, diesel, paraffin, etc. Not suitable for strong acids, alkalis, wastewater, industrial gases, and other media.

Installation:
1. Before installation, keep the pipe as clean as possible.

2. Before installation, check that the pressure, temperature, and voltage correspond to the actual parameters on the solenoid valve's nameplate.

3. Install using a wrench. of the valve body, then screwed onto the pipe, do not force the coil, in order to prevent the solenoid valve from bending and deforming, and loose connections from leading to leaks.

4. The solenoid valve should be immersed in liquid a few times after installation and run properly before formal use.

5. The inlet pressure of the solenoid valve must be higher than the outlet pressure; otherwise, the solenoid valve will not open normally.

Maintenance:
1. Regularly clean the valve housing parts, disassemble them, and check for any broken seals.

2. If the solenoid valve is installed in a branch, the diameter of the solenoid valve must be smaller than that of the main pipe.

3. If the solenoid valve has not been used for a long time, it should be immersed in liquid several times and run properly before being put into service. Official use.


Specifications:

Input Voltage: AC 220 V ± 10%;

Power: 15 W;

Thread Size: G1/2" BSPP (DN15);

Flow Diameter: 16 mm;

Pressure: 0-1.0 MPa;

Liquid Temperature: -5 °C to 150 °C;

Type: Normally Closed (N/C);

Protection Rating: IP 65;

Seal Material: Viton;


Package Contents:

1 x G1/2" Brass Magnetic Valve