2m Throttle Cable, Weatherproof Stainless Steel PU Manual Throttle for Excavator Mixer

Features:

1. APPLICABLE EQUIPMENT: This throttle cable is suitable for excavators and mixers. 2m long cable to meet your needs!
2. QUICK RESPONSE: Adjust the throttle opening and closing via the cable for a quick, immediate response. The throttle is sensitive and available at all times.
3. PU AND STAINLESS STEEL MATERIAL: The hose is made of high-quality PU, which can be bent freely and does not easily deform. The joint is made of stainless steel, which can withstand weathering and environmental conditions. The throttle cable can be used unaffected by external factors and has long durability and a long service life.
4. EASY INSTALLATION: Easy to install without modification, and can be installed directly after removing the old throttle cable.
5. Ideal Replacement: This cable is an ideal replacement for old and damaged parts for improved equipment control.

Specifications:

Item Type: Throttle Cable
Material: PU, Stainless Steel
Applicable Model: Excavator, Mixer
Size: Approx. 2m / 6.6ft
Introduction: The cable throttle is connected to the throttle pedal at one end and to the throttle valve at the other end via a fulcrum and guide. When the throttle pedal is pressed, the throttle opens to a corresponding angle. Therefore, the throttle can be controlled more directly and quickly, and the throttle response is faster and more timely.

How to Use:

1. First, thread the throttle line through the top cover of the carburetor, then place the spring on the throttle line, then extend the throttle line through the throttle hole, pull it out of the slot near it, then wrap it around the bottom, and place the end of the throttle line into the groove for the Mekong at the bottom of the throttle hose. 2. When installing the throttle valve in the carburetor, pay attention to the small slope of the throttle valve facing the idle screw, and then the long groove facing the side with a raised point in the carburetor downwards, then tighten the cover. At this point, the throttle valve can be seen from the throat of the carburetor at the bottom. 3. Open the piston cover, then pass the throttle wire through the middle of the spring on the piston cover. 4. Pass the throttle cable through the plug hole, then lock and secure it with screws to complete the installation.

Package List:

1 x throttle cable