2P DC1000V Photovoltaic Surge Protector – IP20 Flame Retardant – 20kA Discharge Current – ​​35mm Guide Rail for Easy Installation

Rapid Response: With nanosecond response speed, the protector will open immediately to introduce a surge to the ground in the event of a stroke or surge. Rated voltage Ue: 1000 V DC. Maximum continuous operating voltage Uc: 1060V DC.RAIL INSTALLATION: This 2P surge protector device is installed with standard 35MM guide rail, which is very simple to install, can be used with the distribution box circuit breaker.FIREPROOF The photovoltaic surge protector adopts PC fireproof housing, highly safe and reliable to use. The power must be turned off before installation and operation under voltage is strictly prohibited.2. It is recommended to connect the circuit breaker or circuit breaker in series to the front end of the lightning protection module.3.When installing, please connect according to the installation diagram, where + is the positive wire, - is the negative wire, and PE is the ground wire. Don't plug it in wrong. After installation, close the circuit breaker switch (fuse) and check whether the working condition is normal.4. After installation, insert the module into place and check whether the anti-cooperation module works normally.5. During the use of the lightning protection module, the status of the fault display window should be regularly detected and checked. When the fault display window is red or the remote signal terminal gives an alarm signal, it means that the lightning protection module is faulty and needs to be repaired or replaced in time.6. The lightning protection module of the parallel power supply must be installed in parallel. The thread of