3-piece garage door remote control cloning kit, 433 MHz wireless universal remote control key fob duplicator

Package includes:

3x cloning remote controls

Product manual

Specifications:

- RF Frequency: 433MHz

- Battery: 2x CR2016 (included)

- Buttons: 4 buttons

- Transmitter Range: Open space, more than 50 meters

Please confirm three conditions before purchasing.

1: The original remote control is working normally.

2: The frequency: 433.92MHz.

3: The chip code (encoder chip) is as shown below

2260, 2262, 1527, PT2264, PT2240 (LX2240, LX2241, SCL2240), CS5211, SMC918, AX5026, SMC926, AX5326-3, AX5326-4, FP527, HT600, HT680, HT6207, HT6010, HT6012, HT6013, HT6014, HT12D, HT46F49E, PIC16F630, ULN2003

Reset:

Press and hold "A" and "B" keys together --- The LED will flash 3 times. Then release the "B" key (while the "A" key is still pressed) and click the "B" key 3 times --- The LED will flash and then turn off. Success.

Programming

1. Place the original remote and the cloning remote back-to-back. Ensure they are in direct contact. The two remotes should be placed as close together as possible (place them side-by-side on a desk with no distance between them).

2. Press and hold a button on your original remote, then press and hold a button on your cloning remote. Continue holding until the LED flashes twice (Note: the LED flashes twice to prevent releasing the button). Then it will flash three times and remain steady, indicating successful cloning.

If, for any reason, the clone does not flash beyond two times, it means the signal is not being transmitted. Slowly move the remote up and down until you find the point where the signal is present.