30HAS DC 12V Detraginage Timing Module Module Timer Board 0,1 to 5 seconds

Functionality:

1. In using the chip of time dedicated 555 as control main, the time is precise and stable.

2. The settings of the cavalier of the card you allow of switch between the functions HAS and B. The value by fault is defined on a mode.

3. Fit the time with a resistance adjustable with a range of delay of 0,1 to 5 seconds.

4. No start external is not required and the power enter automatically condition of delay.

5. The voltage of operation of design typique is of 12V DC.

6. Standby only of the current 3MY, of energy saving.

7. Power supply has a protection anti-reverse, and power supply reverse desactive nor burn the module.

Specification:

Condition: 100% new

Item Type: module of relay of delay of delay

Voltage: DC 12V (10V-15V can be used)

Consumption energy: travailant 0,04W

Work: 1.0W

Mode of start: Start the timing on the setting under voltage

Range of time: 0,1 to 5 seconds

Precision retards: 1%

Load: AC 250V 30HAS or DC 30V 30HAS

Output form: HAS group of normally agm + normally closed

Can be trempage on perpendiculaires two modes of operation:

R: Power supply immediately, after l'arrivee of the delay, disconnected (maintenue disconnected up to this that input either off);

B: It will not operate after power-on, and will be turned on after the delay arrives (always on until the input is powered off).

HAS Mode: After the module is connected to the power ripple, the red indicator light indicates that the power is on. The relay works immediately and the green indicator light is on. At this time, the normally agm and common terminals are switched to the on state (the normally closed terminal is disconnected). - After has period of time, the relay is turned off and the green indicator is off. At this time, the normally agm and the common terminal are switched off (the normally closed terminal is turned on). Keep this state until the input is powered off.

Mode B: When the module is connected to power supply, the indicator red indicates that power supply is on. The relay bouge not, the indicator green on not, and the terminal normally open and the terminal commune remain to condition outside of power supply front ignition (the terminal normally closed is activated). After a period of time, the relay is on and the indicator green is on. TO hour dcconsommation, the terminal normally open and the terminal commune are basculees to condition ON (the terminal normally closed is disconnected). Fender this condition up to this that input either off.

Package List:

1 x Time Delay Relay Module