3pcs 433.92Mhz Universal Wireless Copy Remote Control Key Fob RF Transmitter for Clone Garage Door Gate Opener 433Mhz Duplicator

【Super Design】Universal RF 433Mhz wireless remote control. It is a duplicator that can clone other remote controls. Strong signal can pass through walls, floors, doors, panels, etc. It can be controlled within 50 meters in open area.

【Wide coding range】2260,2262 (such as PT2262, SC2262, HS2262, LX2262, HX2262, etc.), 1527 (EV1527, HS1527, HX1527, SC1527, GP1527, CP1527, AD1527, SCL1527, TL1527, ZX1527) PT2264, PT2240 (LX2240, LX2241, SCL2240), CS5211, SMC918, AX5026, SMC926, AX5326-3, AX5326-4, FP527, HT600, HT680, HT6207, HT6010, HT6012, HT6013, HT6014, HT12D, HT46N00F49E, PIC different chip manufacture has different chip model prefix, everything will be fine, as long as the chip model numbers are the same

【Easy to use】 Three conditions must be confirmed before purchase. ①The original remote control works normally. ②The frequency must be 433.92Mhz. ③The chip code (encoder chip) as shown. Not all remote controls can be copied. This copy remote control can only copy part of the remote control.

【More flexibility】 There are 4 buttons on the remote control, which means you can clone 4 buttons. Each button works independently. The clone remote control can be reset and configured without limitation.

【Wide Application】The products can be used in homes, farms, factories, offices, laboratories, supermarkets, etc. You can use the copy remote control to clone many remote controls. such as, garage door, electric door, shutter door, expansion door and electric curtain, fan, lamp, lighting, ventilation device, signal transmission and so on.

Package includes:

3x clone remote controls

Product manual

Parameter:

- RF frequency: 433MHz

- Battery: 1x 27A 12V (included)

- Button: 4 keys

- Transmitter range: The open space is more than 50 meters

Please confirm three conditions before purchasing.

1: The original remote control works normally.

2: The frequency: 433.92Mhz.

3: The chip code (encoder chip) as shown below

2260,2262,1527, PT2264, PT2240 (LX2240, LX2241, SCL2240), CS5211, SMC918, AX5026, SMC926, AX5326-3, AX5326-4 , FP527, HT600, HT680, HT6207, HT6010, HT6012, HT6013, HT6014, HT12D, HT46F49E, PIC16F630, ULN2003

Reset:

Press and hold "A" and "B" keys together --- The LED will flash 3 times. And then release the "B" key (meanwhile, the "A" key is still held down) and click the "B" key 3 times --- The LED will flash and then turn off. succeed.

Programming

1. Put the original remote and the cloner remote in "back to back" position. Make sure they have direct contact. Either the two remotes should be placed as close as possible (place the two remotes on the desk side by side with zero distance).

2. Press and hold a button on your original remote, then press and hold a button on your cloner remote. Keep holding until the LED flashes 2 times (Note: LED 2 flashes so don't release the button) Then flashes 3 times then stays solid and you have successfully cloned.

If for some reason the clone doesn't go past 2 flashes, it means the signal is not going through, please slowly move the remote up and down until you get to the point where it will go through.