3P+N 10A C curve residual current circuit breaker 6kA EN61009

1) Complete 3-in-1 protection for your circuitsThis miniature residual current circuit breaker with overcurrent protection (RCBO) combines in a single device overload protection, short-circuit protection and residual current protection against current leakage. In the event of a fault (damaged cable, faulty appliance, moisture causing leakage to earth, insulation fault, etc.), it cuts off the power supply more quickly than a simple circuit breaker, helping to reduce the risk of electric shock and limit electrical fire outbreaks. It is a particularly popular solution when you want to secure a line without multiplying the modules in the consumer unit.2) 3P+N configuration suited to three-phase networksThe 3P+N format is designed for three-phase installations (3-phase networks with neutral). It allows all three phases to be protected simultaneously while integrating the neutral (N) connection, which suits common distribution circuits in homes, small commercial premises and light workshops. Ideal for outgoing lines supplying three-phase loads or sub-distribution boards, as well as for dedicated branches in shops, offices, technical rooms, racks or IT cabinets, or small industrial equipment.3) C10A rating, a versatile choice for common usesWith a rated current of 10 A (C10) and a type C tripping curve, this model aims for a highly sought-after balance: avoiding nuisance tripping while maintaining an effective response in the event of a fault. The C curve is generally recommended for many standard uses such as lighting, low-power dedicated sockets, small equipment and certain appliances with a moderate inrush current (for example light air conditioning or a small pump depending on sizing). The right choice should still be confirmed according to the cable cross-section, line length and the electrical design of the installation.4) 6 kA breaking capacity, greater peace of mind in the event of a short circuitDuring a short circuit, a protective device must be capable of interrupting a very high current. With a 6 kA breaking capacity, this residual current circuit breaker is suited to many outgoing circuit protection needs in standard distribution boards. It provides an appreciated safety margin for domestic installations and small professional installations, where interruption robustness is a decisive criterion.5) Complies with EN 61009 and designed for AC 50 or 60 Hz networksComplying with EN 61009 (residual current circuit breakers with overcurrent protection), this product is intended to operate on AC 50 to 60 Hz networks and service voltages indicated as AC 230 or 400 V (depending on the network configuration). For reliable installation, it is recommended to carry out wiring strictly according to the markings (phases and neutral), tighten the terminals to the appropriate torque and install the device in a suitable consumer unit. Important note: data not provided (e.g. residual current sensitivity 30 mA or 100 mA, tripping time, dimensions, DIN rail type, connection range) is not invented; if you give it to me, I can complete a technical data sheet ready to publish in EU e-commerce format.