1/4
433.92 MHz remote control, compatible with EcoStar RSC2-433, RSE2-433, RSZ1-433, 2-channel remote control for Hörmann EcoStar Liftronic 500/700/800, Porttronic D2500/D5000/S4000, 3-pack--DTEKGAZ
Sold by re-green GmbH
You may also like
Compare with similar items
Product information
Description
This garage door remote control is a replacement part and not an original accessory. Please check the list of compatible devices below before purchasing. [Compatible] Our replacement remote control is compatible with the Hormann EcoStar RSC2-433, RSZ1-433, and RSE2-433 models. It is also compatible with the Hormann Liftronic 500/700/800 garage door openers and the Portronic D2500/D5000/S4000 swing gate openers. [Not Compatible] Our replacement remote control is not compatible with the Ecostar RSC4-433-BS, RSZ1-433-BS, Liftronic 500-2, Liftronic 700-2, and Liftronic 800-2 models. [Frequency] 433.92 MHz, Range: 50–100 m. Two buttons for controlling up to two open garage doors. The remote control comes with batteries and is ready to use immediately – the perfect replacement. [Easy operation with instructions] Instructions for easy handling are included. Lightweight and easy to carry, the remote control can also be attached to your backpack as a decorative item. 1. Compatible with Hörmann EcoStar 433.92 MHz rolling code remote controls. 2. Not compatible with the EcoStar BS series and the Liftronic II series. 3. High-quality replacement product, easy to program and use. Please open the receiver from the garage door before programming. STEPS: 1. Press the programming button. (On some receivers, the programming button must be held down.) 2. The LED on the receiver indicates that programming mode has started. 3. Press and hold any button on the new remote control for one second, then release it. 4. The LED on the receiver will light up or turn off to indicate successful programming. 5. Wait a few seconds to exit programming mode. Programming is complete. Why doesn't the LED light up, or only dimly, when you press the buttons on the illuminated remote control? This could be due to a dead or weak battery. If the indicator light still doesn't illuminate after replacing the battery, check if the button or the remote control is damaged. Attention! Programmer's comment?
Features
- BrandDTEKGAZ
- Range5000 cm
- Motorisation accessory typeRemote-control
- Motorization compatibilityYes
- ManoMano ReferenceME218796015
You are here:
'/%3E%3C/svg%3E){kind=small}