48 Pcs Air Sander Pneumatic Eccentric Grinder for Oxide Removal and Detail Cutting (2)

1. Dedicated to all kinds of light and small metal curves, spray polishing, grinding, oxide removal, and detail cutting. 2. 3. You can adjust the airflow to control the grinding, polishing, and deburring speed. 4. 3 sizes x 6 types of automatic polishing pads to meet your various needs. 5. Complete tools, ready to use, suitable for DIY enthusiasts. Specification: Item Type: Air Sander Optional Style: American Air Nozzle, European Air Nozzle, Japanese Air Nozzle Material: Stainless Steel Model: AT-1500 No-Load Speed: 15000 (rpm) Air Inlet Size: 1/4 (inch) Compressed Air Flow: 12 cfm Exhaust Address: Rear Exhaust Air Connection Screw: 1/4-19NPT Noise Value: Less than 83 dB Suggested Air Tube Inner Diameter: Approx. 6.3 mm / 0.2 inch Category: Oscillating Pneumatic Eccentric Machine Requirements Tips for Oscillating Pneumatic Sander: 1. This machine is very precise. When working, the speed is high. If a thin or iron file enters the movement, it can break the blade and damage the machine, so ensure the air inlet is clean. 2. Ensure you use an oil-water separator and drain the machine regularly to ensure it is dry. 3. Before using the machine, be sure to add 3-5 drops of pneumatic oil to the machine's inlet and connect the air pump while it is idling. To change the eccentric pneumatic grinding disc: 1. Locate the locking eye. 2. Insert the positioning pin into the locking hole and hold the pin in place. 3. Turn clockwise and replace the disc. Size: approx. 2.5 cm / 1 inch 5.1 cm / 2 in 7.6 cm / 3 in Package list: 1 x ponder 3 x 1 inch / 2 inch / 3 inch polishing discs 9 x 1 inch / 2 inch / 3 inch flat sponge pads 9 x 1 inch / 2 inch / 3 inch separator pads 3 x 1 inch / 2 inch / 3 inch microfiber mats 6 x 1 inch / 2 inch / 3 inch artificial wool pads 15 x 1 inch / 2 inch / 3 inch sandpaper pads 1 x positioning block 1 x 1/4" air inlet connector