4P 32A miniature circuit breaker curve C 6kA 230-400V EN60898-1

1) Reliable protection against short-circuit and overload (without residual current protection)This 4P C32A miniature circuit breaker (MCB) is designed to protect your electrical circuits effectively in the event of a short-circuit or overload. It trips automatically to cut off the power supply and limit conductor overheating, damage to appliances or the risk of incidents. Please note: this model does not include residual current protection (no earth leakage detection). It therefore does not replace a residual current device (RCD) or a residual current breaker with overcurrent protection (RCBO) for personal protection. In damp areas (kitchen, bathroom, outdoors, workshops), or for socket circuits likely to be touched, it is recommended to combine it with suitable residual current protection.2) 4-pole configuration: ideal for three-phase 230/400 V and complete disconnectionWith its 4 poles (4P), this circuit breaker is particularly suitable for three-phase + neutral (3P+N) installations, commonly found in small commercial premises, workshops, shops or for certain equipment (pumps, ventilation, small groups of machines). The 4P format allows simultaneous disconnection of the phases and the neutral, appreciated during maintenance operations and in scenarios where more complete isolation of the circuit is required. It is also suitable for electrical panels requiring control and protection on four conductors.3) European electrical characteristics: C32, 6 kA, 50/60 HzThis MCB is rated for a nominal current of 32 A (C32), to be selected in line with the cable cross-section, line length, installation conditions and the actual load. A rating that is too high may reduce the effectiveness of conductor protection. Its C tripping curve offers a good compromise for most common uses, accepting a moderate inrush current at start-up (e.g. lighting, socket circuits, small motors/fans) while remaining responsive in the event of a fault. The 6 kA breaking capacity meets the needs of many residential and commercial applications. For environments where the prospective short-circuit current is higher (close to a transformer, high power), an assessment by a professional is recommended. Compatible with AC 230-400 V and 50/60 Hz.4) Compliance with EN 60898-1 and panel integrationDesigned in accordance with EN 60898-1, this miniature circuit breaker meets the usual performance and safety requirements associated with modular protection devices intended for low-voltage installations. Its miniature format makes integration into a distribution board (electrical enclosure) easier and allows clear organisation of outgoing circuits: lighting, sockets, dedicated lines, equipment power supply, etc. For a durable installation, it is essential to follow good practice: correct tightening of terminals, identification of conductors, checking tightening torque and verifying overheating after commissioning.5) Advice on selection and use: size correctly, add residual current protection if necessaryA C32A should be chosen primarily to protect the line (cable) and not to support more. If the load is heavy or continuous, checking the cross-section and thermal conditions is essential in order to prevent an undersized cable from overheating before tripping occurs. As this is a model without residual current protection, personal safety against insulation faults will depend on an upstream RCD/RCCB or a dedicated solution. Installation and maintenance must be carried out by a qualified electrician, with upstream power isolation and compliance with distribution board wiring rules. This product is therefore intended for users looking for a 4P, curve C, 32 A, 6 kA, 230/400 V MCB, for standard protection against overload and short-circuit, with a European approach to compliance and safety.