5A DC motor drive module, CW/CCW rotation, PWM control, dual H-bridge

Features:

1. Can independently control two motors; each channel can output 5A, above 9A; standby current is only 10µA.
2. Wide power supply range: 3-14V; signal supply range: 2.2-6V; 3.3V and 5V levels can be met.
3. The board provides a 3.3V 100mA power supply to meet the power consumption of your control system.
4. The two-way H-bridge motor can drive two DC motors or one 4-wire stepper motor simultaneously.
5. There is a printed prompt on the back of the circuit board to indicate the pinout.

Specification:

Item Type: Dual Motor Driver Module
Power Supply Module: 3~14V
Signal Input Voltage: 2.2~6V
Mounting Hole Diameter: 2mm / 0.08in
Weight: 14g / 0.49oz (Approx.)

Package List:

1 x Driver Module

Note:

When the motor is communicating, it must wait for the motor to stop first; otherwise, the instantaneous current will burn the module's driver chip. The exposed pins on the back of the board must not be short, otherwise... Permanent damage may occur. Do not connect the positive and negative terminals of the power supply, or it will overheat and burn out. There is a printout prompt on the back of the circuit board.