5A MPPT solar panel charge module controller with charge indicator function

1. 5A step-down constant current/constant voltage module with MPPT function. Charging a battery with a solar panel can more than double the charging current, effectively shortening charging time and reducing the size of the solar panel. 2. It can charge batteries, lithium batteries, etc., with a charging indicator function for easy monitoring of the charging status. 3. This DIY regulated power supply with constant current function is protected against short circuits during use, thus safeguarding the load. 4. The product can power your electronic devices. 5. Drive high-power LEDs, which can be connected in series or parallel.

Specification:

Features: 1. 5A step-down constant current/constant voltage module with MPPT function. Charging a battery with a solar panel can more than double the charging current, effectively shortening charging time and reducing the size of the solar panel.

2. It can charge batteries, lithium batteries, etc., with a charge indicator function to facilitate observation of the charging status. 3. DIY is a regulated power supply with a constant current function. It is not afraid of short circuits during use, which can protect the load. 4. The product can power your electronic device. 5. Drive high-power LEDs, which can be connected in series and parallel. 6. As a car power supply, power your mobile phone or various digital products. Specification: Condition: 100% Brand New Item Type: Charging Module Module Name: 5A Step-Down Constant Current MPPT Input Voltage: 6-36V Output Voltage: 1.25-32V Continuously Adjustable (Default Output 5V) MPPT Voltage Setting Range: 6-36V Output Constant Current Range: 0.05-5A (Default Output Constant Current is 3A) Output Turn-Down Lamp Range: 0.01-5A (Default Turn-Down Lamp Current is 0.3A). The actual range may vary slightly due to differences in room parameters. Operating Temperature: -40~+85°C Operating frequency: 180 kHz Conversion efficiency: 95% (efficiency depends on input, output voltage, current, and voltage difference) Short-circuit protection: Yes (limiting current is the set constant current value) Overheating protection: Yes (automatically shuts off the output after overheating) Input reverse connection protection: No (if necessary, insert a diode at the input) Output reverse polarity protection: No Size: Approx. 60 x 31 x 22 mm / 2.4 x 1.2 x 0.9 inches (L x W x H)

Package list: 1 charging module.

Instructions: Charging indication: Red light while charging, green light when fully charged. The flashing detection method is current.

When using solar panels to provide power, the solar charging current is also low, lower than the rotational current, and also lights up green, but it is not fully charged at this time. Please be careful to distinguish between the two. Using a live meter will show the charging current more directly. Installation method: 4 x 3 mm screws. Wiring method: terminal block (for the wire when the casing is extended). IN is the input, OUT is the output. Note: 1. Be sure to add blocking diodes when the output is connected to the battery, otherwise the module will be damaged! Remember! 2. The module's current detection is low-range. Please do not directly short the negative input terminal and the negative output terminal.