6-380V water flow switch, automatic adjustment controller, change detection for industrial mechanical pipe fittings

Features: 1. Brand new and high quality. 2. Used to detect changes in the flow rate of liquids flowing in pipes, such as water, ethylene, ethylene glycol, or other non-hazardous liquids. 3. When the liquid flow rate exceeds or falls below the set flow rate, its single-pole, double-throw (SPDT) switching contact can make one circuit conductive while breaking the other circuit. 4. The flow switch is generally used in locations where interlocking or 5. The STFS-25 fully sealed liquid flow switch can use different slurries depending on the flow rate of the installed pipeline. Specifications: Features: Brand new and high quality. Used to detect changes in the flow rate of liquids flowing in pipes, such as water, ethylene, ethylene glycol, or other non-hazardous liquids. When the liquid flow rate exceeds or falls below the set flow rate, its single-pole, double-throw (SPDT) switching contact can make one circuit conductive while breaking the other circuit. The flow switch is generally used in locations where interlock or "cut-off" protection is required. The fully sealed STFS-25 liquid flow switch can be used with different slurries depending on the flow rate of the installed pipeline. Specification: Voltage range: 6-380V Pipe fittings: 1" 11-1/2 NPT Bellows and blade material: Phosphor bronze and stainless steel Blade: 1", 2", 3", 6" Liquid temperature (℃): -25-120 Maximum liquid pressure (bar): 15 Installation and adjustment: 1. Open the flow switch housing; 2. The switch is factory-set to the minimum flow value. Increase the flow setting value and turn the adjustment screw clockwise; 3. Press the target part to check if the microswitch can function normally. Excessive counterclockwise rotation of the screw will cause the switch to malfunction. Incorrect adjustment may cause the flow switch to fail; 4. After installation, press the flow switch several times to check the pulp bar. If there is no "click" when the pulp bar returns, turn the adjustment screw clockwise until a "click" is heard; 5. The black lacquer seal adjustment screw is only for factory use to adjust the flow meter; please do not modify or adjust it; 6. Observe three operating cycles to ensure the switch and connected system function normally, and replace the switch housing promptly. Package List: 1 x Liquid Flow Meter, 1 x Chinese and English Manual, 4 x Target Parts