868MHz Remote Control for Hörmann HSE4 BS, 4 Channel Replacement Remote Control for Hörmann, Gate and Garage Door Remote Control Compatible with Hörmann HSM4 HSE2 HS1 HS4 HSZ1

Frequency: 868MHz. Compatible Models: HS1-868-BS, HS1-868-BS, HS4-868-BS, HS5-868-BS, HSE1-868-BS, HSE2-868-BS, HSE4-868-BS, HSP4-868-BS, HSD2-868-BS, HSS4-868-BS. Note: Not compatible with other brands and frequencies. Two programming modes. Mode 1: Continuous code. Note: Continuous code (blue LED) is factory-set. If the original remote uses a continuous code (red LED), it will not function correctly. Mode 2: Face-to-Face Copy Press and hold the button on the new remote that needs to be programmed with the original remote's code, then press that button three times and all other buttons until the indicator light illuminates, then release all buttons. Programming via the receiver. If the original remote has been lost, you can use the receiver to program a new remote directly. 1. Locate the "LEARN" or "PROGRAMMING" buttons on the receiver, press them, and the indicator light will start flashing. 2. Press the buttons on the new remote while they are flashing until the receiver's indicator light flashes rapidly to indicate that the new remote has been successfully programmed. Mode 2: Face-to-Face 1. Press and hold the button on the new remote to memorize the code of the original remote. Then, press the button three times and press all the other buttons until the indicator light illuminates. Release all buttons. 2. Press the button as close as possible to the left or right side of the original remote. 3. Press and hold the buttons on the original remote for 13 seconds until the LED flashes alternately red and blue; the learning procedure is complete. 4. The new remote is programmed. Repeat the procedure with the other buttons. NOTE: You have 15 seconds to transmit the code. If the radio code is not successfully transmitted within this time, repeat the procedure.