AC90V-256V Radio Receiver Remote Control Transmitter System Light/LED Lamp Water Pump Cover Push Button Transmitter Receiver Wireless Transmitter Receiver Garage Door 433MHz 1 Momentary Channel

This product is controlled by an intelligent microprocessor and can be used for garage door control, lighting control, remote control of curtains, access control systems, and various motor control systems. It is small, easy to install, safe, and reliable. The circuit board dimensions are 35 x 32 x 17 mm. This 90V-256V single-channel learning code remote switch is ideal for electrical control circuits such as burglar alarms, electric doors and windows for remote control, signal control, industrial control, drives, etc. Applications include: lights, TVs, motors, fans, cameras, video signals, audio signals, electric doors/locks/windows/blinds/cars, and other devices. Wireless control is easy to install. You can turn the receiver on/off with the transmitter (remote control) from a reasonable distance in any location. You can use two or more units in the same location. Range: approximately 100 m (maximum sensor/signal range under optimal conditions, or in open field/when connected to vision). The wireless RF signal can pass through walls, floors, doors, or windows. Reliable control: The receiver only works with transmitters using the same code. One or more transmitters can control one or more receivers simultaneously.

Package Contents
1 x Remote Control
1 x Receiver

Receiver
Channel: 1 channel
Radio Frequency: 433 MHz.
Supply Voltage: 90-256 V AC.
Coding Type: Learning Code.
Maximum Operating Current: 10 A.
Operating Temperature: -10 °C to +70 °C.
Antenna: With internal antenna.

Control Mode Description:
Toggle (Press button -> Open; Press button again -> Closed.)
Latch (Press button -> Open, Press the other button -> Closed.)
Momentary (Press and hold the button -> Open; Release the button -> Closed.)

Control Mode
Jumper on 2 & 3 → Toggle
Jumper on pin 1 → Momentary
Jumper on 1 & 2 → Latch

Code Learning
Learning: Press the learning button when the display is off, then press the remote control. The light will turn on, indicating successful learning.
Code Deletion: Press and hold the learning button for approximately 8 seconds. The display will turn ON. Then press the remote control. The receiver will not operate, indicating that all stored codes have been successfully erased.