AC90V-256V Radio Receiver Remote Control Transmitter System Light/LED Lamp Water Pump Cover Push Button Transmitter Receiver Wireless Transmitter Receiver Garage Door 433MHz 1 Momentary Channel

This product is controlled by an intelligent microprocessor and can be used for garage door control, light control, remote control of curtains, access control systems, and various motor control systems. Small, easy to install, safe, and reliable. Board dimensions: 35 x 32 x 17 mm.
Single-channel 90V-256V learning code remote switch, ideal for electrical control circuits such as burglar alarms, electric doors and windows for remote control, signal control, industrial control, drives, etc. Applications: lights, TVs, motors, fans, cameras, video signals, audio signals, electric doors/locks/windows/blinds/cars, or other devices.
Wireless control, easy to install. You can turn the receiver on/off with the transmitter (remote control) from a reasonable distance in any location. You can use two or more units in the same location.
Range: approximately 100 m (maximum sensor/signal range under optimal conditions, or in open field/when connected to vision). The wireless RF signal can pass through walls, floors, doors, or windows. Reliable control: The receiver only works with transmitters using the same code. One or more transmitters can control one or more receivers simultaneously.

Package Contents
1 x Remote Control
1 x Receiver

Receiver
Channel: 1 channel
Radio Frequency: 433 MHz.
Power Supply Voltage: 90-256 V AC.
Coding Type: Learning Code.
Maximum Operating Current: 10 A.
Operating Temperature: -10 °C to +70 °C.
Antenna: With internal antenna.

Control Mode Description:
Toggle (Press the button -> Open; Press the button again -> Closed.)
Latch (Press the button -> Open; Press the other button) -> Closed.)
Momentary (Press and hold the button -> Open; Release the button -> Closed.)

Control Mode
Jumper on pins 2 & 3 → Toggle
Jumper on pin 1 → Momentary
Jumper on pins 1 & 2 → Latch

Code Learning
Learning: Press the learn button when the display is off, then press the remote control. The light will illuminate, indicating successful learning.
Code Deletion: Press and hold the learn button for approximately 8 seconds. The display will turn ON. Then press the remote control. The receiver will not operate, indicating that all stored codes have been successfully erased.