Akozon Frequency/Voltage Converter Module 0-10 KHz to 0-10 V, Digital/Analog F/V Module, suitable for PLCs and Frequency Converters, Signal Inputs with Coupling.

Specification: Output Current: 5mA Voltage: 0-10V Input Pulse Level: 5V, 12V, 24V Frequency: 0-10kHz Size: Approx. 4.5 x 4.5cm / 1.77 x 1.77in Weight: 18g Quantity: 1 pc Usage: The multi-ring potentiometer board is used to calibrate frequency and voltage matching. Input supply voltage range: 12-30V DC. (15-24V is recommended) When the electrical level is 12V, the supply voltage should NOT be 12V. It is better to use more than 15V. When the electrical level is 24V, the supply voltage can be 24V. Signal input with optical coupling isolation to ensure anti-interference capability. For use with the NPN type supported by the PLC. Must have a ground wire. For the encoder, a constant speed of the encoder must run continuously for more than 0.5 seconds. Frequency-to-voltage converter module, response time is approximately 0.3 to 0.5 seconds. If the signal input is a flow rate of, etc., an 817 optical coupler and a resistor are required to match the flow meter normally due to signal matching. Corresponding relationship: When the F/V with the resistor is transferred to an intermediate value, F/V corresponding to the following relationship, 100Hz = 0.1V, the accuracy is 1%. It cannot reach 2 decimal places if a relatively high accuracy of the occasion is insufficient. 0.1 V = 100 Hz 500 Hz = 0.5 V 1 kHz = 1 V 2 kHz = 2 V 3 kHz = 3 V 4 kHz = 4 V 5 kHz = 5 V 6 kHz = 6 V 7 kHz = 7 V 8 kHz = 8 V 9 kHz = 9 V 10 kHz = 10 V Each 0.1 V DC corresponds to a 100 Hz frequency. When the correspondence, if allowed, can be corrected by adjusting the potentiometer of the