Anti-slip adhesive tape with luminous film that glows in the dark, safety tape for stairs, ladders and slippery floors, indoor and outdoor use, 10 m x 5 cm -

• LIGHT REMINDER: The tape with green fluorescence film will glow in the dark So you can use it to highlight stairs and easier to see to avoid tripping on the last step at night.
• ADD GRIP TO PREVENT SLIPPING: The tape is made from 80-grit aluminum oxide that creates superior, long-lasting traction on the slippery area. So you don't have to worry about slipping and you will feel safer to go up or down stairs.
• DURABLE ADHESIVE & RESIDUE FREE: High quality glue resists cracking and peeling. At the same time, when you need to replace or reposition, it will not leave any residue or damage your flooring.
• SUITABLE FOR SCOPE: Ideal for highlighting stair nosings, dangerous steps. Such as loading dock edges, basement stairs, cinema stairs, bunk bed ladders, garage and any other areas potentially dangerous.
• APPLY & SIZE: Easy to install and use, simply peel the stick and roll out the bubbles; Size: 50mm width x 10m long, Luminous.

Specification

Main material: gravel, paper, strong glue, fluorescen

Applicable temperature: 14-140? / -10-60?

Suitable for: flat, clean, smooth and hard floors or surfaces (e.g. floors, stairs, steps, corridors, ramps, vehicle steps, emergency exit ladders, scaffolding, cinema aisles, etc.)

Not suitable for: rough, soft, damp, dusty or porous floors

HOW TO USE?

1. Make sure contact surfaces are flat, clean and dry when applying.

2. Cut the ribbon to the desired length and round the corners with scissors.

3. Peel the release paper and place it in the desired location. (When the temperature is low, heat slowly with a hair dryer and buff with good results).

4. Pressure is applied evenly from the center of the strip to both ends. (The applied tape waited 24 hours)

5. Place the tape on a light source for a while so that it glows in the dark.

Advice

The tape absorbs 15 to 20 minutes. The light source may remain light for a while. (The more light is absorbed, the lighter and more durable the light is, then it is slowly weakened)

If the light line is weak, no problem, it is quite bright immediately after "charging" with light.

LRFR is committed to providing each customer with the highest possible quality of customer service.