Black plastic brush holder caps for electric motors – Outer diameter 16 mm, Height 8 mm, pack of 4

General Description: Round black plastic carbon brush cap, used as a cover for installing carbon brushes in power tools. This cap is suitable for most motors, including those used in hammers, power saws, power grinders, and cutting machines. Technical Specifications: Outer Diameter: 16 mm / 0.63 inch Height: 8 mm / 0.31 inch Material: Plastic Pack of 4 caps Installation: To install the cap, first remove the carbon brush holder, then remove the old caps. Replace them with the new caps provided. Ensure the square rear cap of the brush holder is pressed against the electrical contact piece before securing it. Verify that the outer diameter of the cap matches the diameter of the hole where the carbon brush is installed. Use: This cap is a good replacement for old carbon brush caps. It offers good resistance to heat, wear, and corrosion, as well as good water and dust sealing. Additional information: Measure the old cap with calipers. If the measured diameter is approximately 11.5 mm, it is recommended to order a 12 mm carbon brush cap. Please pay attention to the size before ordering.