Brake Pipe Flaring Tool Kit with Single Nozzle, Brake Line Tools with 7.6m Brake Hose, 0-180° Tube Bender, Mini Pipe Cutter, 16 Fittings and 4 Connectors

🚗Cinter Txb 3 yn 1 -- Suitable for softer and thinner materials, such as brass and aluminum tubes with diameters of 6 mm, 8 mm, and 10 mm. The bending angle is 0 to 180°. Accuracy can be achieved by aligning the scale to meet different requirements. If the tube is hard, it is recommended to heat-treat it before use.
🚗Expansion Tool -- The flaring tool is suitable for brake lines with outside diameters of 3/16", 1/4", 5/16", 3/8", 1/2", and 5/8". Before flaring, ensure the tube end is flat and clean, free of chips or other impurities. During operation, apply even pressure to avoid uneven or damaged flares.
🚗Tyau Frein Brake Line -- The 7.6 m long, 3/16" diameter copper alloy brake line is easily flexible and break-resistant. It includes 16 fittings with a 3/16" inner diameter but varying outer diameters. Four of the connectors are compatible with 3/16" (3/8-24) fittings. They can be used together to ensure a strong and reliable joint without damaging the tube. 🚗Mine Cope-Touquet -- The cutter is suitable for cutting tubes with diameters from 3/16" to 5/8" (3-16 mm). To use, first tighten the setting screws, then rotate the cutter. During the cutting process, gradually tighten the screws to increase cutting pressure, rather than applying too much force at once. In the end, you get a clean and well-cut tube.
🚗Service Ateliernonné -- we thank you for your trust and are happy that you chose us. Your opinion is important to us. If you have any questions or suggestions, please write to us. We would like to take care of your wishes.

Suitable for softer and thinner-walled materials such as brass and aluminum tubes with diameters of 6 mm, 8 mm, and 10 mm. The bending angle is from 0 to 180°. Accuracy can be achieved by aligning the scale to meet different requirements. If the tube is hard, it is recommended to heat-treat it before use. -- The flaring tool is suitable for brake lines with outside diameters of 3/16, 1/4, 5/16, 3/8, 1/2, and 5/8. Before flaring, ensure the end of the hose is flat and clean, free of splinters or other contaminants. Pressure must be applied evenly during operation to avoid uneven or damaged flares. -- The 25-foot-long 3/16 copper alloy brake line is easy to bend and difficult to break. There are 16 inverted tube nuts with a 3/16 inner diameter but different outside diameters. Four of them are only suitable for 3/16 threaded fittings (3/8-24). They can be used together to create a strong and reliable seal without damaging the hose. -- The pipe cutter is suitable for cutting pipes with a diameter of 3/16 to 5/8" (3-16 mm). To use it, first tighten the adjustment screws, then rotate the pipe cutter. During the cutting process, the screws should be tightened gradually to increase cutting pressure, instead of applying too much force at once. In the end, you will get a clean and tidy pipe. -- Thank you for your trust and we are happy that you have chosen us. Your opinion is important to us. If you have any suggestions, please feel free to write to us. We would be happy to accommodate your requests.