Car Parking Barrier Loop Detectors Inductive Vehicle Loop Detector/Loop Sensor for Vehicle Access

1. The pulse relay can be configured to activate vehicle detection or when the vehicle leaves the loop. 2. This feature determines the non-detection level at maximum sensitivity to avoid detecting vehicles such as large trucks. 3. Sensitivity can be changed using four sensitivity settings on the switch. 4. Four frequency configurations can be used to prevent signals from interfering with adjacent loops. 5. This relay is generally used to prevent false detection of small or fast moving objects. Specification: When the detector is tuning, the green channel LED and red power LED will light up. There are approximately 2 seconds remaining then the green LED goes out. If there is a loop failure, the channel LED will light up and flash to indicate a fault. If the fault is self-healing, the detector will continue to operate.The green channel LED also lights up as soon as the vehicle is detected to pass through the inductive loop. The red power LED on the top of the unit will remain lit, indicating that the unit is powered on. Features: The pulse relay can be configured to activate vehicle detection or when the vehicle leaves the loop. This feature determines the non-detection level at maximum sensitivity to avoid detecting vehicles such as large trucks. Sensitivity can be changed using four sensitivity settings on the switch. Four frequency configurations can be used to prevent signals from interfering with adjacent loops. This relay is generally used to prevent false detection of small or fast moving objects.Features: tat: brand new Material: ABS Color: black Reaction time: 10 ms Supply voltage: 220 V Power consumption: 4.5 VA Output relay: 240 V/ 5 A DC voltage tolerance: ±15% AC withstand voltage: +10%/-15% Operating temperature: -20°C to +65°C Storage temperature: -40°C to +85°C Frequency range: 20 kHz to 170 kHz Sensitivity: adjustable in 4 increments Signal hold time: unlimited/limit cycle for 10 minutes continuously Loop inductance: the total loop plus the connection line is 50?H at 1000?H (ideally 100?H at 300?H). Loop connection wiring: Maximum length 20 meters, twisted at least 20 times per meter. Package list: 1 * gate opener 1 * connection terminal 1 * instruction manual Note: 1.The detector should be installed in a convenient waterproof position as close to the loop as possible.2.The installation location should be chosen far from the heat source. 3.Other equipment around it should be at least 10mm away (should not be firmly attached to the wall). 4. Proper loop configuration and detector installation will ensure a successful inductive loop detection system. 5.Several important parameters of the loop include: cycle diagram, size, turn and installation method. 6.Please note that the new type and old type of this product will be sent randomly, and make sure you do not mind before ordering.