CJMCU FT232H High Speed Multifunction USB to JTAG UART/FIFO SPI/I2C Module

1、Single channel USB to serial / parallel ports with a variety of configurations.

2、Whole USB protocol handled on the chip, no USB specific firmware programming required.

3、USB 2.0 high-speed (480Mbits/Second) and full speed (12Mbits/Second) compatible.

4、Multi-protocol synchronous serial engine (MPSSE) to simplify synchronous serial protocol (USB to JTAG, I2C, SPI (MASTER) or bit-bang) design.

5、UART data transfer rate up to 12Mbaud (RS232 data rate is limited by external level shifter). 6、USB to synchronous 245 parallel FIFO mode transfer up to 40 megabytes/second. 7、USB to asynchronous 245 fifo mode data transfer rate up to 8 megabytes per second. 8、Support for special half-duplex FT1248 interface with configurable width, bidirectional data bus (1, 2, 4 or 8 bit wide). 9、CPU - style FIFO interface mode simplifies CPU interface design. 10、Fast serial interface option. 11、FTDI’s royalty-free Virtual Com Port (VCP) and Direct (D2XX) drivers eliminate the requirement for USB driver development in most cases. 1

2、Adjustable receive buffer timeout.Condition: 100% Brand New

Item Type: USB to JTAG UART/FIFO SPI/I2C Module

Typical Applications

Single chip USB to UART (RS232, RS422 or RS485)

USB to FIFO

USB to FT1248

USB to JTAG

USB to SPI

USB to I2C

USB to Bit-Bang

USB to Fast Serial Interface

USB to CPU target interface (as memory).w-e-text table td,.w-e-text table th,.wang-edit-text table td, .wang-edit-text table th{border: .5pt solid #000;};.w-e-text table,.wang-edit-text table{border: 1px solid #000 !important;}

1 x Module3 x Pin Header