Digital Angle Protractor, Stainless Steel Angle Ruler for Carpenters and Sliding Bevel, 360° Measuring Range, Steel Ruler for Woodworking, DIY, Crafts and Hobbyists

• 2 in 1 Digital Protractor - Measure not only length, but also 360° angle (inside angle, outside angle). Locking function Use locking screws to lock both legs in the desired position or desired angle.
• Large 1" LCD display - LCD with electronic digital display, you can switch between degrees and minute with the "°/" button. The ?HOLD? button stores data during measurement, the ?ON/OFF/Zero? button resets the data to zero by short press at any angle; angle lock button for each angle.
• Length, width and accuracy – Length measurement: 400 mm; Measuring angle: 000.0°~999.9°; precision; ±0.3°; resolution: 0.1°; Measuring range: 0-360°. The body of the ruler is forged from high quality stainless steel, this which guarantees quality, corrosion resistance, and durability.
• Excellent Quality - The high-quality stainless steel forged scale is laser-engraved (mm and inch scale), abrasion and corrosion resistant.
• High-Quality Service - If you have any questions about use, installation, or the product, you can contact customer service.

Multifunctional This angle finder ruler can measure both angle and length, on both metric and imperial scales. Woodworking: Setting angles for table saws, miter saws, band saws, etc. Construction Sketching, draw Convenience Quickly measure angles with an accuracy of ± 0.3 degrees. (± 0.3 degrees means that the measurement result may be higher or lower than the actual angle by a maximum of 0.3 degrees. The total difference between two measurements can be up to 0.6 degrees.) Easy to use with only two buttons. A good locking function allows you to lock the measurement at any angle. Compact design for convenient transport and use. Accessibility * The scales of this digital angle finder are made of durable brushed stainless steel. * The angle finder can be used in various fields instead of an angle ruler, straight edge, or square. etc. * Easily draw lines with the stainless steel rulers. Technical description and operation Measuring range: 0° ~ 999.9° (must be calibrated before each use) Resolution: 0.1 Folded length: 220 mm Accuracy: ± 0.3° (± 0.3 degrees means that the measurement result may be higher or lower than the actual angle by a maximum of 0.3 degrees. The total difference between two measurements can be up to 0.6 degrees). Extended length: 400 mm Ruler measuring range: 0 ~ 400 mm; 0 ~ 7 inches Measurement: Laser engraving Operating temperature: 0 ~ 50°C. Set includes: Protracor stainless steel * 1, CR2032 battery * 1. Battery: CR2032 3V lithium battery Note: All data is measured manually, please allow a 1-3 cm error. Due to differences in lighting and display, there may be some color variation; the actual product received shall prevail.