Digital diesel fuel flow meter, 15-120L/min turbine flow meter, 1" NPT diesel fuel meter water flow meter

Features: 1. Its modular design makes it suitable for use with output modules, sensors, and remote transmitters. 2. Lightweight and compact structure, easy to install. 3. Clear and intuitive display, high reliability, measurement accuracy of ±1%. 4. High-definition displays show both instantaneous and cumulative flow rates. 5. Can be widely used to measure diesel, urea, kerosene, gasoline, etc. Specifications: This digital turbine flow meter has a modular design, high accuracy, compact size, and stable performance. Internal components are easy to replace and maintain. Suitable for use with output modules, sensors, and remote transmitters. Features: The modular design makes it suitable for use with output modules, sensors, and remote transmitters. Lightweight, compact structure, easy to install. Clear and intuitive display, high reliability, measurement accuracy of ±1%. High-definition displays show both instantaneous and cumulative flow rates. Can be widely used to measure diesel, urea, kerosene, gasoline, etc. Specification: Thread Size: 1 inch NPT Female Material: Plastic Color: Blue Repeatability: ±0.5% Measurement Accuracy: ±1% Maximum Working Pressure: 20 BAR Flow Range: 0-90 L/min, 25-150 L/min, 35-250 L/min Single Count: 0.00-9999.9 Total Cumulative Count: 0-999999 Coefficient of Error: 0.1000-9.9999 Unit: L / GAL / PTS / QTS Operating Temperature: -10°C ~ +60°C (14°F ~ 140°F) Operating Voltage: 2.3-3.3 V Application: Diesel, Urea, Kerosene, Gasoline Battery Type: 2 AAA LRO3 Batteries Weight: 270 g / 9.5 oz (approx.) Package List: 1 x Turbine Flow Meter Note: Please note The new and old types of this product will be shipped randomly, so please ensure this is acceptable before ordering. Troubleshooting and Solution: The flow meter is inaccurate. 1. The on-site calibration method was incorrect. Recalibrate. 2. The flow rate indicated on the meter is below the minimum. Increase the flow rate. 3. The flow meter is blocked by dried fluid. Remove the impeller, clean it thoroughly, and ensure it rotates freely. 4. The impeller is encased in sealing material. Remove the meter and ensure the impeller rotates freely. 5. Too close to the impeller. Install correctly. 6. Too close to the engine or noisy electronic environment. Install correctly. The readings have faded or disappeared. 1. The battery is depleted or disconnected. Check the batteries or replace them. The flow rate is normal, but the meter cannot register. Press the DISPLAY button; the meter will start. 1. The on-site calibration is incorrect. Recalibrate. 2. The turbine is blocked or damaged. Remove the meter and ensure the turbine spins freely. 3. The turbine is encased in sealing material. Remove the meter and ensure the turbine spins freely. The flow rate is low and the meter cannot register. Press the DISPLAY button; the meter will start. 1. The flow meter is blocked by dried liquid. Remove the turbine, clean it thoroughly, and ensure it spins freely. 2. The flow rate indicated on the meter is below the minimum. Increase the flow rate. The meter cannot be calibrated. 1. The circuit board is faulty. Replace the circuit board. 2. The button cannot be pressed. Replace the circuit board.