Environmental Signal Output 0-5V 360 Degree Polycarbonate Transmitter Wind Speed ​​Sensor Anemometer (9.3 x 7.3 Inches)

1. Small and lightweight, easy to carry and assemble, 8-way adjustable, and easy to use.
2. It is made of a polycarbonate housing, which offers high mechanical strength, high hardness, corrosion resistance, and rust resistance.
3. Exposure-resistant, high impact resistance, long service life, suitable for long-term use in outdoor environments.
4. With a smooth internal bearing system, data collection accuracy is effectively ensured, and operation is more convenient.
5. High-performance bearings, low rotational resistance, accurate measurement, electromagnetic interference protection, can be used with both four-wire and three-wire connections.

Specification:

Condition: 100% Brand New
Item Type: Wind Direction Sensor.
Material: Polycarbonate
Wide Voltage: 10-30V DC power input.
Application: Widely used for wind direction measurement in greenhouses, environmental protection, weather stations, ships, docks, livestock farming, and other environments.
Parameter:
DC Power Supply (Default) 10-30V DC
Maximum Power Consumption Output Voltage 1.2W
Emitter Circuit Operating Temperature -20°C at +60?, 0%RH-80%RH
Dynamic Response Time ?0.5s
Output Signal Voltage Output 0-5V
Load Capacity Voltage Output Resistance ?600?
Calculation Method:
Output Comparison Table 0-5V
Output Value (V) Corresponding Wind Direction
?0 North Wind
?0.7143 Northeast Wind
?1.4286 East Wind
?2.1429 Southeast Wind
?2.8571 South Wind
?3.5714 Southwest Wind
?4.2857 West Wind
?5 Northwest Wind Product Size: approx. 23.5 x 18.5 cm / 9.3 x 7.3 inches
Weight: approx. 315g / 11.1oz
Common problems and solutions:
No output or output error possible causes:
1) The error corresponding to the range causes the calculation error of the PLC. Refer to the technical specifications of the range.
2) The wiring method is incorrect or the wiring sequence is incorrect.
3) The supply voltage is incorrect (24V supply for the 0-10V type).
4) The distance between the transmitter and the collector is too long, causing signal interference.
5) The PLC's collector port is damaged.
6) Physical damage.

Package List:

1 x Wind Direction Sensor 1 x Cable 1 x Screw Kit (4 x Screws, 4 x Nuts)

Note:

1. The user should not disassemble it themselves and should not touch the sensor core to avoid damaging the product. 2. Keep the transmitter as far away as possible from high-power interference equipment such as inverters, motors, etc., to avoid inaccurate measurements. When installing or removing the transmitter, the power supply must be disconnected first, as water inside the transmitter can cause irreversible damage. Prevent chemicals, oil, dust, etc., from directly contaminating the sensor. Do not use it for extended periods under condensation or in extreme temperature environments, and avoid sudden temperature changes.