Fiber Optic Cleaver SKL-6C High-Cut Fiber Optic Knife Tools Precision Fiber Cleaver

The fiber optic cleaver is suitable for cold splicing and can handle hot splicing, making it a versatile fiber optic cutter.

The SKL-6C fiber optic cleaver uses 16-bit high-strength blade designs.

It has a longer lifespan, comes with a triple attachment for flexing, cutting fiber and bare fiber, and features an automatic rear knife slide.

Easy to use. You just need to put a good fiber cover over the lid.

Then, to push through, you can complete the entire cutting process.

Specification:

Applicable fiber rod diameter: 125mm.

Applicable fiber core quality: Single core (0.25 and 0.9 mm), 2.5-fiber 12-core tape-covered wire.

Optical fiber cutting length: 18mm.

Usage:

1. Lift the upper lever of the optical fiber cover. Open the clamp of the single-core fiber clamp. Confirm the blade slider in the forward position.

2. Place the optical fiber in the groove of the single-core fiber clamp. Align the coating line with the appropriate cutting length scale for the optical fiber. (For example, if the cutting length is 18 mm, align the coating line to the 18 mm position on the scale). Next, check the bare fiber to ensure it is straight.

3. Optical fibers and chips are very small and sharp. If one penetrates a finger or eye, it will cause injury. Therefore, you must be very careful during the operation. For safe use, the operator must wear safety glasses.

4. Please dispose of the fiber chips in the designated container, separate from household waste.

Warning:

1. When replacing the non-optical adjusting blade, you may not be able to replace and install the blade or adjust the cutting force.

2. The SKL-6C uses a special cutter fixing screw, eliminating the need to adjust the cutter height even when rotating the cutter bar. (Become very rich)