Flood Barrier Threshold Bar Seal Interior Folding Door Strip Shower Bathtub Wall for Wet and Dry Separation Suitable for Kitchen and Bathroom (100cm, White)

Foldable and waterproof: The self-adhesive sealing strip of the dam is placed firmly to prevent water from flowing out. It is waterproof and foldable. It can be flexibly folded according to the shape of your furniture to form a small waterproof dam, providing good water blocking effect. The shower grate is white in appearance, which can perfectly match the surrounding environment Advanced Materials: The shower threshold dam is made of high-quality TPE, healthy, environmentally friendly, waterproof, mildew-resistant and non-deformable. Separate dry and wet. You can easily cut it to the desired length and the water retention tape is flexible enough to create different shapes. Soft and Harmless: The waterproof belt is soft and will not hurt your feet, so hitting it can ensure the safety of you and your family.The surface is easy to clean, just wipe with a damp cloth, like new. Easy to Install: 1. Wipe the floor with a cloth. 2. Highlight the location. 3. Remove the primer and stick the water retention strip according to the marked position. 4. Push the water lock lever into place. 5. Stretch the water retention strips at both ends and stick them on both sides 6. Let sit for 24 hours. Usage function: The water stop strip has the ability to stop water and is suitable for bathrooms, kitchens and sinks.Waterproof and dustproof, forming dry and wet separation protection, to ensure that your floor is dry and clean; this way, while keeping your family safe, it can also be used flat under a smooth wooden door or glass door Shower Seal -Easy to cut: create different shapes to fit your bathtub or kitchen sink. -Very suitable for showers without curves and other areas that must contain water: under the shower curtain, next to the shower tray, bathroom thresholds, countertop sinks, washing machines, sinks. Specification: Color: white, black, gray, transparent Material: TPE Length: 100cm Installation steps: * Firstly, please clean the floor thoroughly and keep it dry. This step is very important! *After that, determine the installation position of the water retention strip, and then mark on the ground with a pen.*Remove the adhesive tape on the back of the water retaining strip and stick it on the floor according to the previously marked position. * Finally, to avoid falling, please dry within 24 hours to avoid contact with water. Note: Clean the surface thoroughly and ensure it is dry before installation, and remove any existing water stops. Please use a hair dryer to heat the glue before use to achieve better adhesion. [Special reminder] The water retaining belt can be used with glass glue. Apply glue to both sides of the waterproof barrier and spread it evenly. If both sides and both ends are fixed with glass glue, it can extend its service life.