Goofit Single Pulse Generator (Crankshaft Position Sensor) Compatible with John Deere Gator XUV 625i (PC90957) and XUV 620i (PC9618) Original Ignition Sensor

【Special John Deere Gator XUV Sensor】This crankshaft position sensor was specifically designed for the John Deere Gator XUV 625i (part number PC90957) and XUV 620i (part number PC9618) utility vehicles. It meets original equipment specifications and is engineered to withstand the vibrations and thermal stresses encountered in off-road and harsh operating conditions. It accurately detects crankshaft speed and position, providing the engine control unit (ECU) with the pulse signal needed to calculate the ignition timing. This critical sensor component ensures efficient engine starting, stable idling, and reliable performance. **[Precise Model Compatibility]** This product is compatible with the following John Deere Gator models and ensures a precise match with the original electrical and physical specifications of the vehicle: John Deere Gator XUV 625i (product reference: PC90957) and John Deere Gator XUV 620i (product reference: PC9618). (Note: This product is specifically designed for the Gator models listed above with specific configurations. Before purchasing, please check your vehicle's configuration label (usually on the chassis or under the seat) to confirm PC number compatibility. It is also recommended to check the appearance or part number of the original part for final confirmation.) **[Resolves Starting and Running Issues on Electronic Fuel Injection Engines]** Replacing the vehicle's original sensor effectively resolves the following issues in cases of internal coil damage, magnet failure, thermal aging, or signal deviation:

Engine does not start or starts with difficulty (no crankshaft signal)

Rough idle, frequent stalling

Slow power delivery, jerky acceleration

Check engine light illuminates and crankshaft position sensor trouble codes (e.g., P0335) may be displayed and stored. [Professional Installation and Air Gap Adjustment]

This product is a precision electromagnetic component. It is typically mounted near the flywheel housing or the control housing cover. Proper installation requires precise adjustment of the air gap between the sensor head and the trigger teeth of the flywheel (or signal disc). This air gap must be set exactly using a non-magnetic feeler gauge (e.g., between 0.3 and 0.8 mm), strictly adhering to the specifications in the official John Deere Service Manual. An incorrect air gap will directly result in signal errors or malfunctions of the engine control system.

[Scope of Delivery]

Single Pulse Generator × 1 piece