Goofit Single Pulse Generator (Crankshaft/Camshaft Position Sensor) For EZGO Golf Carts (1991–2003) Original Part Number: 28458-G01--DTEKGAZ

【EZGO Golf Cart Ignition Sensor】Single pulse generator (crankshaft/camshaft position sensor), specifically designed for gasoline-powered EZGO golf carts from model years 1991–2003. This product meets original EZGO specifications and is identical to original part number 28458-G01. The rugged, oil- and dust-resistant housing is designed for frequent starting and stopping, as well as the stresses of low-speed, high-load golf cart operation. The sensor accurately detects engine speed and position, delivers a stable ignition pulse signal to the ignition control unit (e.g., CDI or distributor), and is a critical component for reliable starting, stable idling, and preventing engine stalling. [Compatible with 13-Year-Old Golf Cart Models] This product directly replaces part number 28458-G01 and is suitable for EZGO gasoline golf carts manufactured from 1991 to 2003 (typically with 295cc or 350cc Robin engines or similar). (Note: This product is fully compatible with EZGO golf carts of the above model years that use this part number. Before purchasing, please check the part number in your golf cart repair manual, on the original parts, or confirm the final version using your golf cart's model and serial number.) [Fixes Golf Cart Starting and Driving Problems] Replacing the original sensor effectively resolves the following issues caused by worn internal coils, magnet failures, damaged wiring harnesses, or corroded connectors: difficult or impossible engine starting; rough idling; frequent engine stalling; Sudden loss of power or unexplained engine stalling while driving; slow acceleration, loss of power. [Professional Installation and Air Gap Adjustment] This product is a precision electromagnetic induction component, typically mounted near the flywheel housing or distributor cap, and operates via the trigger terminal on the flywheel. Crucial to correct installation is the precise adjustment of the air gap between the sensor head and the trigger terminal on the flywheel. The air gap must meet strict requirements (typically 0.3 to 0.8 mm) and be adjusted according to the manufacturer's instructions using a non-magnetic feeler gauge. An incorrect air gap will result in a weak or no signal. [Package Contents] 1 Single Pulse Trigger Module