Goofit Single Pulse Generator (Ignition Sensor) For Kasinski Mirage 250 Motorcycles (2001–2009) Magneto-Stator Signal Detection Coil Replaceable Part--BIEMMEDUE

【Special Individual Ignition Sensor for Kasinski Mirage 250】This independent individual ignition sensor (crankshaft position sensor) was specifically designed for Kasinski Mirage 250 motorcycles (2001-2009). As an essential component of the ignition stator, it detects the flywheel position, generates a precise ignition pulse signal, and sends it to the CDI ignition module. This electronic component ensures proper ignition, starting, and engine operation, and is ideal for targeted repairs, thus avoiding the need to replace the entire stator. [Compatible with certain models and years] This product is specifically designed for the Kasinski Mirage 250 model from model years 2001 to 2009 and meets the specifications of the original ignition system. (Important Note: This product is a model- and year-specific replacement part. However, parts information for Kasinski vehicles is relatively limited, and there may be differences between production batches. Before purchasing, you should remove the original part to perform a full visual comparison, or provide the seller with clear photos of the old part from various angles along with your Vehicle Identification Number (VIN) to confirm compatibility.) [Targeted Solution for Ignition Signal Faults] If your Mirage 250 is experiencing typical ignition system faults, such as starting problems (the starter motor turns but the spark plugs do not fire), difficulty starting, sporadic stalling, or misfiring at high RPMs, and if an ignition signal problem is suspected after troubleshooting, replacing this independent ignition sensor is an economical and effective repair solution. [Professional Installation and Precise Air Gap Adjustment] This product is a precision electromagnetic induction component. Installation requires removing the magnet cover; The flywheel may also need to be removed. The biggest challenge during installation is precisely adjusting the air gap between the ignition coil's induction head and the sensor connection on the flywheel. This air gap is extremely critical and tiny (typically 0.2 to 0.8 mm) and must be set exactly using a non-magnetic feeler gauge. An incorrect air gap will directly result in a signal loss. [Scope of delivery] Single-pulse ignition coil × 1 piece