Goofit Single Pulse Ignition Sensor For Kawasaki Mule 3000 Series Utility Vehicles Part Number: 59026-2065 / 59026-0559 Spare Part Crankshaft Position Sensor

[Special Crankshaft Position Sensor for Kawasaki Mule 3000 Series] This single-pulse crankshaft position sensor was specifically designed for the Kawasaki Mule 3000 series off-road vehicles. It meets original Kawasaki specifications and is compatible with part numbers 59026-2065 and 59026-0559. Its sealed, oil- and vibration-resistant housing allows it to operate in the harsh conditions of off-road vehicles, especially under heavy loads. It accurately detects the crankshaft position and delivers a stable and precise pulse signal to the ignition control unit. This vital electronic component ensures reliable starting, smooth running, and optimal performance. [Compatible with Mule 3000 Models] This product directly replaces part numbers 59026-2065 and 59026-0559 and is suitable for Kawasaki Mule 3000 models with these part numbers (common in models from the first half of the 2000s). (Note: This product is fully compatible with both of the part numbers listed above. Please check the part number in your vehicle's owner's manual or on the original parts before purchasing to ensure compatibility with your Mule 3000 model.) [Fixes Starting and Performance Issues on UTVs] Replacing the original sensor, which can fail due to internal coil aging, magnet failure, wiring harness wear, or moisture, effectively resolves the following issues: difficulty or inability to start the engine; unexplained engine stalling or sudden loss of power while driving; rough idling, poor acceleration; no spark (after checking the ignition coils and CDI). [Professional Installation and Air Gap Adjustment] This product is a precision electromagnetic induction component, typically installed inside the flywheel housing or magneto cover. Precise adjustment of the air gap between the sensor head and the sensor teeth on the flywheel (or signal pinion) is crucial for successful installation. The air gap must conform to the strict factory specifications (usually 0.3 to 1.0 mm) and be set according to the operating instructions using a non-magnetic feeler gauge. An incorrect air gap will directly result in a weak or missing signal. [Scope of delivery] Single pulse trigger × 1 piece