HX711 Weight Measurement Module + 4 Strain Gauges (50/100/200 kg) Complete Set for Arduino, Size 34×34 mm

Product Information

24-Bit HX711 Chip This Arduino pressure sensor module uses a high-precision 24-bit HX711 A/D converter chip, designed for high-precision electronic scales. It offers a fast and agile response, accurate measurement data, and near-flawless performance.

128x Gain: The HX711 module has two analog channel inputs with a built-in programmable amplifier with 128x gain.

Versatile Use: The input circuitry can be configured as a bridge sensor and offers bridge pressure sensor modes (e.g., pressure, weight).

This makes it an ideal, high-precision, and cost-effective front-end sampling module. High Sensitivity: The Arduino force sensor is characterized by high precision and sensitivity as well as small size. High Sensitivity: The Arduino force sensor is characterized by high precision and sensitivity as well as small size. HX711 Pressure Sensor, Strain Gauge, Weight Sensor, Arduino Pressure Sensor, Force Sensor, Weight Sensor, 100 kg HX711 Weight Sensor, Arduino Weight Sensor, Strain Resistance Sensor, Body Load Cell Specifications: Sensor Dimensions: 34 * 34 mm / 1.34 * 1.34 in Sensor Construction: 1000 Ohm Half-Bridge Strain Gauge Measuring Range: 50 kg / 100 kg / 200 kg Package Contents: 4 * Arduino Pressure Sensors 1 * HX711 Module User Manual: During measurement, the outside of the sensor must be subjected to an external force. The E-shaped strain gauge bar of the sensor (i.e., the bar arm with the white rubber in the center of the strain gauge) and the outside must exert a shear force in opposite directions. This means that the center of the strain gauge bar can bend under load and that there must be no obstructions on the other side of the strain gauge bar. The sensor contains a set of half-bridge strain gauges that can be used in the following three ways: 1. Use one sensor with an external resistor for a full-bridge measurement. The capacity is the same as that of a single sensor: 50 kg. A higher external resistor is required for this. 2. Use two sensors for a full bridge measurement. The capacity is equal to the sum of the capacities of the two sensors: 50 kg x 2 = 100 kg. Use four sensors for a full bridge measurement. The capacity is equal to the sum of the capacities of the four sensors: 50 kg x 4 = 200 kg. Note: Please be aware that new and older versions of this product will be shipped randomly. Please ensure this is acceptable to you before ordering. Specifications: Width: 10 cm Height: 10 cm Weight: 0.1 kg Color: Black Ref. ManoMano ME96039299 Show all Learn more