Interface diagnostic tester, OPCOM 2012V CAN OBD2 Operator Firmware V1.99, USB, black

OPCOM 2012V Car Interface Diagnostic Tester, CAN OBD2 Operator Firmware V1.99, USB, Black

Features:

Provides comprehensive status information (current, absent, intermittent);

You can print, save, or copy fault codes to any other application;

From the fault code menu, you can directly access the measurement block menu;

Displays information from multiple control modules;

Can display 8 measurement parameters simultaneously;

The sampling rate largely depends on the communication protocol.

1. Covers almost all Opel cars, even newer models with CAN-BUS diagnostic functionality, such as the Vectra-C, Astra-H, and Zafira-B.

2. The program allows you to read and clear fault codes, display real-time data, and perform output tests.

3. The program supports many control units, such as the engine, automatic transmission, ABS, airbag, engine cooling module, instrument cluster, electronic climate control, body control unit, etc.

4. Since Opel uses multiple pins in the OBD connector, the diagnostic interface acts as a multiplexer and selects the appropriate pin for communication.

PIN3, PIN7, PIN8, PIN12 = serial link (ISO9141, KW81, KW82, KWP2000)

5. The error code will be displayed with all available information:

Full description of the error code text:

1) Complete status information (present, not present, flashing)

2) You can print, save, or copy the error codes to any other application. From the error code window, you can directly access the measurement block window.

3) The program will show you measurement block information for many control modules, which you can select from the list.

4) The program can display 8 measurement block parameters simultaneously. The sampling rate largely depends on the communication protocol. For example, older systems such as Omega-B X 25 DT (ISO-9141-2) motors can be very slow in the communication process, while newer Multec or Bosch units are faster (using KWP-2000), and the latest CAN-based control unit is very fast! You can also run output tests on multiple controllers. PIN6-PIN14 PIN3-PIN11 PIN1 HSCAN - High-speed, two-wire CAN-BUS, 500 kbps MSCAN - Medium-speed, two-wire CAN-BUS, 95 kbps SWCAN - Low-speed, single-wire CAN-BUS, 33.3 kbps Packing list: 1 piece x COM port OP

1 piece x USB cable

1 PC x CD with software and drivers

Note: Only 32-bit Windows XP and Windows 7 operating systems are supported; other systems are not supported.