LED strobe warning light for garage doors, 12-265V, wide voltage, for sliding doors, garage door openers

12V 24V 220V LED Lamp. Safety Instructions 1. For safety reasons, please read the user manual carefully before first use; 2. Please ensure the power is switched off before connecting, as the product is manufactured without a fuse; 3. This system must not endanger life or property in the event of a malfunction or safety hazard. have been eliminated. SpecificationsOperating Voltage: 12-265V AC/DCLoad Capacity: 1.5WWeight: 156gFlashing Frequency: 1HzInstallation: Vertical/HorizontalOperating Temperature: -20°C to +60°CProtection rating: IP54Dimensions: 60 x 85 mmNote:1. Terminal 1 is for connecting the power supply; the operating voltage is 12-265V AC/DC. 2. Terminal 2 is for connecting the RF controller antenna to increase the operating range. Instructions: After the lamp is switched on, the LED will flash 1 Hz (default setting). SW1 allows you to select the flashing or on mode. The cap shorts the two pins; the lamp is then in flashing mode. Remove the cap from the two pins; the lamp is then in on mode. Caution: The board contains high-voltage components. Always ensure that the power is switched off before opening the cover.InstallationOpen the packaging and remove the products and all accessories. Remove the antenna by turning it counterclockwise. Mark two holes on the wall at using the mounting hole in the bracket. Drill two 6 mm diameter holes and one 10 mm diameter hole. Then insert the extension plug into the 6 mm diameter holes. Pass the wires through the 10 mm diameter hole. Insert the power cable and antenna into the designated holes in the bracket. Secure the bracket to the wall using the supplied 4 mm x 30 mm self-tapping screws. Connect the cable and antenna to the appropriate terminals. Replace the cover and ensure it is securely attached to the base. Next, screw in the antenna and turn it clockwise to tighten it. Always install the bracket and lamp vertically. Horizontal installation could allow rain to enter the lamp and damage the circuit board.