Long Range (900 metre) Wireless Solar Powered Outdoor Alarm System supplied with:
This is an example of how you can use both the Solar PIR's (900 or 600 metre models) together with any of the Solar Perimeter Beams (1B, 2B or 3B) to make an Outdoor Alarm System to suit your requirements.
You can also add may other accessories to the system (see list below).
Wireless Transmission Range:
The range between the PIR & 1B Beams to the Indoor Receiver is an impressive 900 metres (line of sight) which equates to around 400 - 600 metres in most applications, this distance can be doubled by adding a Signal Repeater (004-2910).
Receiver:
The Indoor 4 - Channel Wireless Receiver is powered by a standard 3-pin Plug in Transformer and has the following features:
1B Beams:
These impressive Solar Powered Wireless Perimeter Beams are packed with impressive features (listed below) and work in conjunction with either of the Wireless Receivers (indoor 004-2790, 004-2880) & (solar outdoor 004-2810), perfect for protecting the outside of homes, farms & businesses:
The Dual Detection Technology works by having a pair of Detectors (set 60 mm apart from each other) on each Beam, both Detectors have to be breached simultaneously to create an activation, allowing small animals, insects, leaves & debris to safely pass by. There are a pair of detectors on each size of Beam, so these 1B-100 have one pair of detectors, a 2B-100 would have two pairs and the 3B-100 would have three pairs, each pair of detectors work independently of each other resulting in the 3B-100 Beams having three chances to detect an Intruder.
The External Beams are also supplied with an additional Charging Port which can be used to give the Beams a boost charge should you experience a lengthy duration of low sun light, or perhaps one of the beams needs to be fitted into a slightly covered location.
They are very easy to install as they have a built in Red Glow Light (for easy lining up).
You can use up to 128 sets of Beams & PIR's with the Internal Receiver & 32 sets with the Solar Wireless Siren, you can mix & match by using a selection of different sizes of Beams within one single system.
Wireless PIR:
The Detection range of the PIR is 20 metres (which can be reduced by choosing one of the other three sensitivity settings) and the detection width is approximately 15 degrees but with a narrow depth.
By fitting the PIR about 1 - 1.5 metres from the ground, it is possible to avoid detecting small ground animals (providing you mount the PIR horizontal to the ground).
It is powered by a built in Battery which is charged and maintained by the Solar Panel supplied, this Solar Panel comes with its own mounting bracket and 1 metre of Cable which is plugged into the back of the PIR.
The benefit of having a separate Solar Panel is that it allows you to fit the PIR in the most suitable position for Detection whilst positioning the Solar Panel in the best location for daylight (to charge the PIR).
You could also connect a charger into the back of the PIR for locations with access to power, or use this port to give the PIR an occasional boost charge if it is mounted in a shady location.
The PIR is supplied with an easy to mount wall bracket.
Remote Controls:
The Remote Controls allow you to pause the Receiver for 5 minutes to allow you to leave the premises without activating the system (designed for use when there are Sirens, Bells & Auto-Diallers attached).
It also allows you to trigger the Receiver using it as a Panic Button (useful again when accessories are connected).
Additional Accessories:
You can add many additional accessories to this Driveway Alarm System building it to your specific applications, the wide range of options include the following, but there are many more:
A unique Wireless Driveway Alarm System, if you need Advice Please Contact US for Friendly, No Obligation Advice !!